Jandy Pro Series PHPF.50 Instruções - Página 4
Procurar online ou descarregar pdf Instruções para Bomba de água Jandy Pro Series PHPF.50. Jandy Pro Series PHPF.50 4 páginas. Lid w/ locking ring and seal, lid seal and lid o-ring, and basket, replacement kit
Imprimir página
Page 4
2.4 Replacing Lid with Locking Ring and
Seal (Kit R0448800)
WARNING
Follow all filter manufacturer's instructions. Never
attempt to assemble, disassemble or adjust the
filter when there is pressurized air in the system.
Starting the pump while there is any pressurized
air in the system can cause the filter lid to be
blown off, which can cause death, serious per-
sonal injury or property damage.
1.
Comply with the warnings and follow Steps 1-5 in
Section 2.1, Opening Pump.
2.
Place the lid onto the pump housing.
3.
Following the markings on the lid's locking
ring, align the 'START' marking with the ports.
Then turn the lid clockwise until the 'LOCKED'
marking aligns with the ports. Do not tighten past
the 'LOCKED' marking.
Zodiac Pool Systems, Inc.
2620 Commerce Way, Vista, CA 92081
1.800.822.7933 | www.ZodiacPoolSystems.com
©2015 Zodiac Pool Systems, Inc. ZODIAC ® is a registered trademark of Zodiac International, S.A.S.U., used
under license. All other trademarks referenced herein are the property of their respective owners.
H0281300 Rev E
Jandy
Pro Series PHP(F/M), WFTR, and MHPM Pumps, Lid w/ Locking Ring and Seal, Lid Seal and O-ring, and
®
|
Basket
Replacement Kit Instructions
2.5 Completing Procedures
1.
If necessary, install any remaining parts. Follow
the appropriate procedures, which are described
in Section 2.2, Replacing Lid Seal or Lid O-ring,
Section 2.3, Replacing Pump Debris Trap Basket,
and Section 2.4, Replacing Lid with Locking Ring
and Seal.
2.
Return the valves to the proper position for normal
operation.
3.
Follow the filter manufacturer's instructions on
how to bleed all air from the filter.
Follow all filter manufacturer's instructions. Never
attempt to assemble, disassemble or adjust the
filter when there is pressurized air in the system.
Starting the pump while there is any pressurized
air in the system can cause the filter lid to be
blown off, which can cause death, serious per-
sonal injury or property damage.
4.
Once all the air has been bled from the filter,
close the filter pressure release valve assembly
or other pressure release means, per the filter
manufacturer's instructions.
5.
Turn on the power to the pump at the circuit
breaker.
6.
Turn on the pump.
7.
Check to see if the pump is operating properly,
with no lid leaks.
8.
If there are lid leaks, repeat the steps in
Section 2, Procedures. For technical support, call
800.822.7933.
WARNING