Brizo SENSORI T66T0 Series Manual - Página 4

Procurar online ou descarregar pdf Manual para Unidade de controlo Brizo SENSORI T66T0 Series. Brizo SENSORI T66T0 Series 20 páginas. Thermostatic valve trim
Também para Brizo SENSORI T66T0 Series: Manual de início rápido (8 páginas), Manual (8 páginas)

Imprimir página

IMPORTANT:

The Rotational Limit Stop is used to limit the amount

of hot water available such that, if set properly, the

user will not be scalded if the handle accidentally is

rotated all the way to "hot" when a person is showering.

The first position allows the LEAST amount of hot

water to mix with the cold water in the system. In the

first position the water will be the coldest possible

when the handle is turned all the way to hot. As you

move the Rotational Limit Stop counterclockwise, you

progressively add more and more hot water in the mix.

The last position to the left will result in the greatest

amount of hot water to the mix, and the greatest risk

of scald injury if someone accidentally turns the valve

handle all the way to the hot side while showering.

WARNING: In some instances, setting the

Rotational Limit Stop in the hottest position (full

counterclockwise) could result in scald injury. It is

necessary to adjust the Rotational Limit Stop so

that the water coming out of the valve will not scald

the user when the handle of the valve is rotated to

the hot side.

• According to the majority of industry standards, the

maximum allowable temperature of the water exiting

the valve is 120°F (Your local plumbing codes may

require a water temperature less than 120°F).

• Run the water so that the cold water is as cold

as it will get and hot water is as hot as it will get.

Place the handle on the stem and rotate the handle

counterclockwise until the handle stops.

• Place a thermometer in a plastic tumbler and hold

102224 Rev. C

in the water stream. If the water temperature is above

120°F, the Rotational Limit Stop must be repositioned

clockwise to decrease valve outlet water temperature to

be less than 120°F or to meet the requirements of your

local plumbing codes.

• To adjust the temperature of the water coming out of

the valve:

Pull the clip (1) from the sleeve (2) and rotational

limit stop (3).

Note the position of the rotational limit stop

(3). Pull the rotational limit stop out from the

sleeve (2) enough so that it can be rotated

clockwise to decrease the outlet temperature

or counterclockwise to increase the outlet

temperature.

Once the desired outlet temperature is reached,

make sure rotational limit stop is pushed back onto

the sleeve so that the clip (1) can be reinstalled.

Make sure clip is secure on sleeve. Reassemble

handle to valve stem.

• MAKE SURE COLD WATER FLOWS FROM THE

VALVE FIRST. MAKE SURE WATER FLOWING FROM

THE VALVE AT THE HOTTEST FLOW POSSIBLE

DOES NOT EXCEED 120°F OR THE MAXIMUM

ALLOWED BY YOUR LOCAL PLUMBING CODE.