KitchenAid KIRD862HSS1 Manual de utilização e cuidados - Página 10
Procurar online ou descarregar pdf Manual de utilização e cuidados para Campânula de ventilação KitchenAid KIRD862HSS1. KitchenAid KIRD862HSS1 16 páginas. 30"/36" retractable downdraft vent systems
Também para KitchenAid KIRD862HSS1: Lista de peças (4 páginas)
Imprimir página
Recommended
standard
fittings
90 ° elbow =
5 ft. (1.5 m)
45 ° elbow =
2.5 f_. (0.8 m)
= Put on gloves and safety
glasses. Place cardboard
or another
form of protection
on top of a flat
surface where you can easily
assemble
the downdraft
vent
system. Remove parts packages,
downdraft
vent and blower
box
from carton. Remove all shipping
materials,
tape and protective
film
from downdraft
vent and blower
box.
over counter
support
arm
= Attach the left side and right
side overcounter
support
brackets
to the downdraft.
Use 1 screw
with each bracket.
end cap
,__
upport
leg
= Attach support
legs to side of
downdraft
vent with two screws in
each leg. Do not tighten
screws.
Excessive
Weight Hazard
Use two or more people to move
and install downdraft vent.
Failure to do so can result in back
or other injury.
= Carefully
insert downdraft
vent into countertop
cutout.Two
people are recommended
to
support the weight of the
downdraft
vent during lifting.
Check that downdraft
vent is
parallel to side of cutout and that
mounting
brackets rest gently on
countertop.
level
mark
cabinet floor. Align top of legs
with pencil marks on face of
downdraft
vent.Tighten
screws
in legs.
7=
Attach 10" (25.4 cm) round
vent collar plate (supplied
with
exterior
blower
system) to front of
downdraft
vent using 4 hex washer
nuts.
= Remove the 2 Phillips-head
screws attaching
the wiring
box
cover and remove cover. Remove
either the back or bottom
knockout
and install conduit connector.
NOTE: Power supply cable needed
between
exterior
blower assembly
and blower
box is not provided.
= Determine
the location where
the exterior
blower
box will be
located. Cut opening
in roof or wall
for vent system to exterior
blower.
Install exterior
blower according
to
instructions supplied
with the
blower
kit.
Wall Installations:
• Use caulking
compound
between
mounting
flange and wall.
Roof Installations:
Follow standard
roofing
procedures.
The flashing
sheet should be
centered over the roof opening.
• Lower edge of flashing should
lie
on top of shingles and upper edge
underneath
shingles.
Seal assembly
between
roof, fan
and flashing with roofing
mastic
to prevent leaks.
_J
\
= Attach the left side and right
side end caps to the downdraft.
Use 1 screw with each end cap.
10
6_
Move support
legs down
against cabinet floor. Place a level
against front of downdraft
vent
base and adjust position
of legs
until downdraft
is level vertically.
Use a pencil to mark the top of
each leg on face of downdraft
vent.
Then mark location of support
leg
mounting
holes on cabinet floor.
Remove downdraft
vent from
cutout. Drill starter holes at each
mounting
screw location
on