KitchenAid GCI3061XB00 Manual de instruções de instalação - Página 6

Procurar online ou descarregar pdf Manual de instruções de instalação para Forno micro-ondas KitchenAid GCI3061XB00. KitchenAid GCI3061XB00 16 páginas. 27" (68.6 cm) and 30" (76.2 cm) electric built-in convection microwave oven

Imprimir página

INSTALLATIONINSTRUCTIONS

4. Remove the bottom vent (bottom vent will be reattached after

_};_"@_}GI_@#_, I{ _" # j M C_©WGV@

C_3w'_C:_,_,_

_z_::: _< _ ,

the microwave oven is installed).

1. Locate existing wiring to avoid drilling into or severing wiring

.............................. \_

during installation.

Excessive Weight Hazard

Use two or more people to move and install

microwave oven.

Failure to do so can result in back or other injury.

2. To avoid floor damage, set the microwave oven onto

cardboard prior to installation. Do not use the handle or any

portion of the front frame for lifting.

3. Remove the shipping materials and tape from the microwave

oven.

4. Remove and set aside racks and other items from inside the

microwave oven.

5. Remove the hardware package from inside the bag

containing

literature.

6. Move the microwave oven and cardboard close to the

microwave oven's final location.

Attach the bottom vent to the spacer bars using two Phillips

head screws, Be sure to use the top, center hole in the spacer

bars,

NOTE: Guide flanges should face inward.

//i:i/

....... C

A. Bottom vent

B. Spacer bars

C. Phillips head screws

D. Guide flanges

1. Center the assembled microwave oven spacer kit in the

cabinet cutout. Push the spacer kit back into the cabinet

cutout until the bottom trim is flush with the cabinet front.

2. Using a 1/8"(3.2 mm) drill bit, drill through the mounting holes

in the spacer bars into the microwave oven support surface

to create pilot holes.

3. Attach the assembled spacer kit to the support surface using

four 3A" pan head screws provided. Do not overtighten the

screws.

A. 3/4"pan head screws

B. Spacer kit assembly

C. Bottom vent

Electrical Shock Hazard

Disconnect power before servicing.

Use 12 gauge solid copper wire.

Electrically ground oven.

Failure to follow these instructions can result in death,

fire, or electrical shock.

This microwave oven is manufactured

with a neutral (white)

power supply wire and a cabinet-connected

green (or bare)

ground wire twisted together.

1. Disconnect

power.

2. Feed the flexible cable conduit from the microwave oven

through the opening in the cabinet.

3. Remove junction box cover if it is present.

4. Install a UL listed or CSA approved conduit connector to the

junction box.

A .............

A. UL listed or CSA approved conduit connector

5. Route the flexible cable conduit from the microwave oven to

the junction box through a UL listed or CSA approved conduit

connector.

6. Tighten screw on conduit connector.

7. See "Electrical Connection

Options Chart" to complete

installation for your type of electrical connection.