Cosco CEB TRIM-280 Manual do Proprietário - Página 11

Procurar online ou descarregar pdf Manual do Proprietário para Aparelho Elíptico Cosco CEB TRIM-280. Cosco CEB TRIM-280 15 páginas. Magnet power,elliptical bike

Imprimir página

Insert the hand pulse wires (24) from hand pulse bar (20) into the hole on the back of Front

upright frame (14) and pull them out from the upper hole of Front upright frame (14). Attach

the hand pulse bar (20) to the groove of Front upright frame (14) with two pcs of arch

spacers (45), and M8X20 bolts (38). (Refer figures 4)

5. Install the Computer

Insert the Pulse wires (24) and Computer wire(26) to the holes on the back of the Computer

(10). Attach the Computer (10) to the top of the Front upright frame (14). (Refer figures 5)

6. Install the Handlebar Support (Right & Left)

Attach two Arc spacers (9)

and Wave washer (28)

the end of horizontal axle of Front upright frame (14).

Insert right Handlebar support (6) to the end of

horizontal axle of Front upright frame (14) and secure

Φ8

it with Plastic flat washer (53),

big washer (49),

(51), M8 Special washer (16), and Bolt

spring washer

M8X20 (36). Finally, assemble the Nut cap (7) to the

Bolt M8X20 (36), then the Handlebar support (6R) can move freely. (Refer figure 6)

7. Install the Pedal Support Tube (Left & Right)

Insert the left Pedal support tube (4) through the

Rear U-shape bracket (35), a Wave washer (28) and

Pedal axis bushing (54) into the Left pedal axis (30).

And then attach the pedal axis (30) to the crank (67)

and tighten them with power support pole and left

lock nut (43).

Do the same steps as above to assemble the right

Pedal support tube (4) to the right pedal axis (31). (Refer figure 7)