KitchenAid KHMC106W Manual de instruções de instalação - Página 12

Procurar online ou descarregar pdf Manual de instruções de instalação para Forno micro-ondas KitchenAid KHMC106W. KitchenAid KHMC106W 16 páginas. 30" built-in microwave/convection hood

Imprimir página

PREPARATION OF WALL AND TOP CABINET

MOUNTING

TEMPLATES

THIS PRODUCT CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING

INSTRUCTIONS FOUND ON BOTH TEMPLATES.

READ AND FOLLOW MOUNTING

INFORMATION

ON BOTH

TOP CABINET

AND

WALL

TEMPLATES

WALL AND TOP CABINET

personal Injury or property Dama*

Hazard

The mounting area on the top cabinet and wall must be capable of supporting a minimum of127 pounds.

Failure to follow these instructions

could result in personal injury and/or property damage.

If the wall is not flat, use spacers to fill gaps. Mounting

plates must be flat for proper installation.

Wall space for installation

should be the same as the wall template.

Make sure the top of the

wall template

is at least 66"from

the floor and at least 30"from

the cooking

surface.

For proper rnstallation

and servicing,

the bottom

of the Microwave

Oven/Hood

system should be

at least 2"above

the backsplash

of the range.

NOW REFER TO THE WALL AND TOP CABINET TEMPLATES.

PRODUCT INSTALLATION

MOUNTING

PLATES

Electrical Shock Harard

Ike special care when drilling holes into the wall.

EkXt&3lwirtZsnla)/beC%nlX&d

llehindBlewaIcauwing.

Contact with them could result in electrical shock

Separate toggle bolts from toggle nuts.

Insert one toggle bolt into each of the selected holes in the

mounting

plates (these holes correspond

to holes in areas

A, B, C

and

ofthe

Wall Template)

and put the toggle nuts

onto the toggle bolts

(Fig, 10).

If a hole is located in a stud,

do not use

toggle bolt. Use

wood screw. If A, B, C, and

D are not located in studs, follow template

instructions

for

E and F.

Position the mounting

plates with the toggle bolts attached

atthewall

locationand

inserttoggle

nutsand boltsthrough

the holes in the wall with the toggle nuts closed.

(Fig. 11).

Use wood screws to attach mounting

plate to studs.

NOTE:

Before insertion,

be sure you leave a space more

than the thickness of the wall between the mounting

plate

and the end of each of the toggle

nuts fin the closed

position).

If you do not leave enough space, the toggle nut

will not be able to open on the other side of the wall. Also,

once a toggle nut opens, it cannot be withdrawn

from the

hole, therefore

make sure all toggles are in the correct

position

before

insertion.

Align the mounting

plates carefully

and hold in position

while tightening

toggle bolts. Pull toggle bolt toward you

and turn clockwise

to tighten

(Fig. 12).

Figure 10

Figure 11

Wall