Makita 197413-5 Manual de instruções - Página 9

Procurar online ou descarregar pdf Manual de instruções para Perfurar Makita 197413-5. Makita 197413-5 12 páginas. Cordless cutter
Também para Makita 197413-5: Manual de instruções (13 páginas), Manual de instruções (13 páginas)

Imprimir página

Water supply

CAUTION:

When filling the tank with water, be

careful not to let the tool get wet.

Be sure that the water supply cock is closed before

filling the tank with water. Open the cap on the tank and

fill the water. Recap the tank.

► 1 . Water supply cock 2. Close 3. Open

1 1

► 1 . Cap 2. Open

OPERATION

CAUTION:

This tool should only be used on

horizontal surfaces.

CAUTION:

Be sure to hold the workpiece

firmly down on a stable bench or table during

operation.

CAUTION:

Do not twist or force the tool in the

cut, or the motor may be overloaded or the work-

piece may break.

CAUTION:

Do not use the tool with the dia-

mond wheel in an upward or sideways position.

CAUTION:

The wheel for this tool is a wet-

type diamond wheel for glass and tile applica-

tions. Be sure to feed water to the diamond wheel

during operation.

CAUTION:

If the cutting action of the diamond

wheel begins to diminish, dress the cutting edge

of the wheel using an old discarded coarse grit

bench grinder wheel or concrete block. Dress by

pressing lightly on the outer edge of the diamond

wheel.

Hold the tool firmly. Set the base plate on the workpiece

to be cut without the wheel making any contact.

Then turn the tool on and wait until the wheel attains

full speed.

Feed water to the wheel by adjusting the water supply

cock to obtain a gentle flow of water.

Move the tool forward over the workpiece surface,

keeping it flat and advancing smoothly until the cutting

is completed. Keep your cutting line straight and your

speed of advance uniform.

For fine, clean cuts, cut slowly. (When cutting glass

plate 5 mm (3/16") thick, cut at about 250 mm/min

(9-7/8"/min). When cutting tile 10 mm (3/8") thick, cut

at about 300 mm/min (11-13/16"/min).) Also slow down

as you complete a cut to avoid breaking or cracking the

workpiece being cut.

NOTE: When the battery cartridge temperature is

low, the tool may not work to its full capacity. At this

time, for example, use the tool for a light-duty cut for

a while until the battery cartridge warms up as high

as room temperature. Then, the tool can work to its

full capacity.

NOTE: Make sure that the water supply cock is

closed before operation.

9 ENGLISH