Makita 6093D Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Perfurar Makita 6093D. Makita 6093D 17 páginas. Equipped with electric brake 10 mm (3/8") with fast charger
Também para Makita 6093D: Manual de instruções (16 páginas)

Imprimir página

IMPORTANT SAFETY

1 .

SAVE THESE INSTRUCTIONS

This manual

contains important safety and operating instructions for battery charger.

2. Before using battery charger, read all instructions and cautionary markings

o n (1) battery charger, (2) battery, and (3) product using battery.

3. CAUTION

To reduce risk of injury, charge only MAKITA Battery 7000,

9000 or 9100. Other types of batteries may burst causing personal injury

and damage.

4. Do not expose charger to rain

or snow.

5. Use of an attachment not recommended

sold by the battery charger

manufacturer may result in a risk of fire, electric shock,

injury to persons.

6. To reduce risk of damage t o electric plug and cord, pull by plug rather than

cord when disconnecting charger.

7. Make sure cord

is located so that

will not be stepped on, tripped over,

otherwise subjected t o damage or stress.

8. An extension cord should not be used unless absolutely necessary. Use of

improper extension cord could result in a risk of fire and electric shock. If

extension cord must be used, make sure:

a . That pins on plug of extension cord are the same number, size, and shape

b. That extension cord is properly wired and in good electrical condition; and

That wire size is at least a s large a s the one specified in the table below.

TABLE 1

RECOMMENDED MINIMUM AWG SIZE FOR

EXTENSION CORDS FOR BATTERY CHARGERS

as those of plug on charger;

Length of Cord (Feet)

100

150

AWG Size of Cord

1 8

9. Do not operate charger with damaged cord or plug

replace them im-

mediately.

IO. Do not operate charger if it has received a sharp blow, been dropped,

otherwise damaged in any way; take it to a qualified serviceman.

1 1 . Do not disassemble charger

battery cartridge; take it to a qualified

serviceman when service or repair is required. Incorrect reassembly may

result in a risk of electric shock or fire.

12. To reduce risk of electric shock, unplug charger from outlet before attempt-

ing any maintenance or cleaning. Turning off controls will not reduce this risk.