Makita 6207D Manual de instruções - Página 6
Procurar online ou descarregar pdf Manual de instruções para Perfurar Makita 6207D. Makita 6207D 12 páginas. Cordless driver drills 10mm, 13mm
Também para Makita 6207D: Manual de instruções (10 páginas), Informações técnicas (13 páginas)
Imprimir página
Selecting action mode
1
2
001897
This tool has an action mode change lever. For drilling,
depress the lock button and then slide the action mode
change lever to the left (
the action mode change lever to the right (
until it is locked. If it is hard to turn the lever, first turn
the chuck slightly in either direction and then turn the
lever again.
CAUTION:
Always slide the action mode change lever all the
•
way to your desired mode position. If you operate
the tool with the lever positioned halfway between
the mode symbols, the tool may be damaged.
Do not use the action mode change lever while the
•
tool is running. The tool may be damaged.
Adjusting the fastening torque
001898
The fastening torque can be adjusted in 16 steps by
turning the adjusting ring so that its graduations are
aligned with the pointer on the tool body.
First, slide the action mode change lever to the position
of
symbol.
The fastening torque is minimum when the number 1 is
aligned with the pointer, and maximum when the
marking is aligned with the pointer. The clutch will slip at
various torque levels when set at the number 1 to 16.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular application.
NOTE:
The adjusting ring does not lock when the pointer
•
is
positioned
graduations.
1. Lock button
2. Action mode
change lever
symbol). For screwing, slide
1. Adjusting ring
2. Graduations
3. Pointer
1
2
3
only
halfway
between
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or drill bit
1
symbol)
001899
Hold the ring and turn the sleeve counterclockwise to
open the chuck jaws. Place the bit in the chuck as far as
it will go. Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve
counterclockwise.
When not using the driver bit, keep it in the bit holders.
Bits 45 mm long can be kept there.
1
001900
OPERATION
Screwdriving operation
001901
First, slide the action mode change lever to the position
of
symbol and select the fastening torque.
Place the point of the driver bit in the screw head and
the
apply pressure to the tool. Start the tool slowly and then
increase the speed gradually. Release the switch trigger
6
1. Sleeve
2. Ring
2
1. Bit
2. Bit holder
2