Makita 6216DWAE Manual de instruções - Página 10

Procurar online ou descarregar pdf Manual de instruções para Perfurar Makita 6216DWAE. Makita 6216DWAE 20 páginas.

CAUTION:

*Always set the speed change lever fully to the correct position. If you operate the tool

with the speed change lever positioned half-way between the "I" side and "11" side, the

tool may be damaged.

*Do not use the speed change lever while the tool is running. The tool may be damaged.

Adjusting the fastening torque

The fastening torque can be adjusted in

steps by turning the adjusting ring

that

its graduations are aligned with the pointer

on the tool body. The fastening torque is

minimum when the number 1 is aligned

with the pointer, and maximum when the

marking is aligned with the pointer.

The clutch will slip at various torque levels

when set at the number 1 to 16. The clutch

is designed not to slip at the

marking.

Before actual operation, drive a trial screw

into your material or a piece of duplicate

material to determine which torque level is

.equired for a particular application.

NOTE:

*The adjusting ring does not lock when the pointer is positioned only half-way between

*Do not operate the tool with the adjusting ring set between the number 16 and the

the graduations.

marking. The tool may be damaged.

Screwdriving operation

Place the point of the driver bit in the

screw head and apply pressure to the tool.

Start

the

tool

slowly and then increase the

speed gradually. Release the trigger as

soon as the clutch cuts in.