KitchenAid MT4110RP Instruções de instalação - Página 2
Procurar online ou descarregar pdf Instruções de instalação para Forno micro-ondas KitchenAid MT4110RP. KitchenAid MT4110RP 4 páginas. Microwave oven built-in trim kit
Imprimir página
Tools Recommended
Assemble the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Measuring tape
Pencil
Parts Supplied
A
C
A. Upper trim piece (1)
B. Duct (1)
C. Lower trim piece (1)
Location Requirements
Check the location where the microwave oven will be installed.
The location must provide the following:
Wood cabinet with opening as shown
Support for weight of 100 lbs (45.4 kg)
Grounded electrical outlet (see "Electrical Requirements"
section) on rear wall of cabinet enclosure
A
B
G
F
A. Cabinet opening
B. Location of grounded outlet
³⁄₁₆
C. 1
" (3 cm) clearance above
opening
¹⁄₂
D. 14
" (36.9 cm) height of
opening
2
INSTALLATION INSTRUCTIONS
Scissors
Phillips screwdriver
B
D
E
D. 4 mm x 8 mm tapping screws (7)
E. 4 mm x 16 mm tapping screws (4)
C
D
E
E. 1" (2.5 cm) min. clearance
below opening
³⁄₈
F. 20
" (51.8 cm) min. width of
microwave oven
G. 16" (40.7 cm) min. depth of
microwave oven
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Observe all governing codes and ordinances. A 120-Volt, 60-Hz,
AC-only, 15- or 20-amp fused electrical supply (or circuit breaker)
is required. (A time-delay fuse is recommended.) It is
recommended that a separate circuit serving only this appliance
be provided.
GROUNDING INSTRUCTIONS
For all cord connected appliances:
The microwave oven must be grounded. In the event
of an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire for
the electric current. The microwave oven is equipped
with a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord
is too short, have a qualified electrician or serviceman
install an outlet near the microwave oven.
For a permanently connected appliance:
This appliance must be connected to a grounded,
metallic, permanent wiring system, or an equipment
grounding conductor should be run with the circuit
conductors and connected to the equipment
grounding terminal or lead on the appliance.