Makita 6228DWE Manual de instruções - Página 10
Procurar online ou descarregar pdf Manual de instruções para Perfurar Makita 6228DWE. Makita 6228DWE 19 páginas. 9.6 v
i2 v
14.4 v
Também para Makita 6228DWE: Manual de instruções (19 páginas), Manual de instruções (19 páginas), Manual de instruções (19 páginas)
Imprimir página
Speed change
To change the speed, first switch off the
tool end then slide the speed change lever
to the "Ill" side for high speed or "l" side
for low speed. Be sure that the speed
change lever is set to the correct position
before operation. Use the right speed for
your job.
Low_
Highspeed
_-- Speed d_nge lever
CAUTION:
• Always set the speed change lever fully to the correct position. If you operate the tool
with the speed change lever positioned half-way between the _1" side end "ll" side, the
tool may be damaged.
• Do not use the speed change lever while the tool is running, The tool may be damaged.
Adjusting the feetonlng torque
The fastening torque can be adjusted in 17
steps by turning the adjusting ring so that
its graduations are aligned with the pointer
on the tool body, The fastening torque is
minimum when the number 1 is aligned
with the pointer, and maximum when the
ill marking is aligned with the pointer.
The clutch will slip st vadous torque levels
when set at the number 1 to 16. The clutch
is designed not to slip at the a marking.
Before actual operation, drive a tdal screw
into your matedal or a piece of duplicate
material to determine which torque level is required for a particular application.
NOTE:
"Do not operate the tool with the adjusting dng set between the number 16 end the
marking.The toolmay be damaged.
• lO