a&p instruments UX 3081 Manual de Instruções - Página 5

Procurar online ou descarregar pdf Manual de Instruções para Instrumentos de medição a&p instruments UX 3081. a&p instruments UX 3081 20 páginas. Moisture analysers

Imprimir página

Operating instructions for moisture analysers

UX 3081

UX 3081WQ

1. 4. Next place one of the two drying trays supplied on

the tray holder using one or two sets of tongs.

The notch in the reflector tray acts as an access

gap for easy positioning of the tray.

1. 5. Check that the voltage indicated on the type plate matches the local mains voltage.

1. 6. The power cable is inserted into the

device's power jack and a suitable

earthed mains supply. After the power

supply has been connected, the

device can be switched on or off using

1. 7. In order to prevent weighing system measuring errors, the device should be switched on 20 minutes

before being used to allow for heat compensation. If weight values vary in the display's milligram range

during this period, this is considered normal within this phase. If the device is switched off using the reset

(on/ off) button, it does not require a warm-up period, if switched on again with the same button.

1 8. ULTRA X moisture measuring devices are supplied, so that in most cases substances can be measured

immediately. If you are not satisfied with the result, the measurement parameters can be adjusted:

Printer

Open Cover:

Hold the green glowing putton

and lift the plastic cover

The ULTRA X Thermo paper is stable for 10 years.

a&p instruments, Kluckhofer Weg 61, D-32657 Lemgo, Tel.:05232 97780, Fax.: 977820

E-Mail: [email protected], Internet: www.apinstruments.de

the on/ off button on the back of the device.

Once the device is switched on, the current

software version is shown, followed by the

weight display.

Change Paper

Line feed

Seite 5