A&R Power Amplifier SA150 Manual do Proprietário - Página 13
Procurar online ou descarregar pdf Manual do Proprietário para Amplificador A&R Power Amplifier SA150. A&R Power Amplifier SA150 14 páginas. Stereo power amplifiers
Também para A&R Power Amplifier SA150: Manual do Proprietário (14 páginas)
Imprimir páginaSA200 Technical Specification
Inputs
Fixed level inputs are connected to pin 3 (LEFT) and pin 5 (RIGHT) of a 5 pin 180° DIN socket
and/or two phono sockets located in the rear sub panel. This sub panel is removable to allow
other types of connector to be substituted, if required.
Sensitivity
1.00V (ref. 100W/8ohms, 1 kHz)
Gain to loudspeaker terminals
29.0 dB at 1 kHz, non-inverting
Signal/noise ratio
> 100 dB, unweighted or CCIR/ARM
weighted, (ref. 100W/8 ohms)
Input impedance
20 kfl
Outputs
Loudspeaker outputs are via red and black heavy duty screw terminals. These will accept bare
wires or 4mm ('Banana') plugs. Suitable for 4-16 ohm loudspeakers.
The continuous power output, both channels driven (at 0.08% t.h.d., 20 Hz-20 kHz), exceeds
lOOW/channel into 8 ohms
160W/channel into 4 ohms
The typical maximum power output at 1 kHz, at clipping (0.1% t.h.d.). both channels driven is
125W/channel into 8 ohms
195W/channel into 4 ohms
Total Harmonic Distortion
At any level up to 100W/8 ohms, 1 kHz < 0.03% (typ. 0.01%)
At any level up to 160W/4 ohms, 1 kHz < 0.05% (typ. 0.02%)
Frequency Response
+ 0, - 0.5 dB 10 Hz-20 kHz. It is recommended that the pre-amplifier's high frequency response
should be curtailed to at least - 3 dB at 50 kHz.
Power Requirements
240 VAC, 48-63 Hz, 600 VA maximum. The unit may be dealer adjusted to work at 220V or
120V if required.
Dimensions (overall)
Width
464mm {IS1/*")
Height
95mm (33/4n)
Depth
350mm {133/4W)
Weight
Net 10.0 kg (22 lb)
Packed 14.0 kg (31 lb)