Align-Pilates C1 Manual de instruções de montagem - Página 4

Procurar online ou descarregar pdf Manual de instruções de montagem para Equipamento de fitness Align-Pilates C1. Align-Pilates C1 16 páginas. Full cadillac

6. Inserting the poles
Ensure the grub screws are loose on all four corners to allow the poles to slot into the receptacles,
(Fig.8). Once you have done this you can insert the two head end uprights, one at a time, into
the receptacles. (Note: The head end uprights have three holes drilled through half way up). Slide
the black quick adjust carriages over the top of each pole and tighten in position, see Fig.9. Be
sure that these uprights are installed at the same end of the frame that has the 4 holes for the
headrest.
Fig. 9
Fig. 8
Insert the other pair of poles in the opposite end with the drilled holes at the top. Once they are
all connected, slide over the roll down bar frame at the foot end as per Fig.10.
Fig. 10
7. Attaching the trapeze carriage
Insert the black corner caps in each upright. (Note: there is only
one way they will all slot in correctly, so take your time and align
the holes correctly). Next, insert the x2 short end pieces.
Slide the trapeze carriage over each of the horizontal cross bars
and insert one end at a time into the corner pieces. Align all the
holes ready for the bolts and then use the bolts with the contoured
Fig. 11
washers and rounded caps, screw each bolt upward through the
horizontal frame pieces.
At each corner use the bolts with eyelets to attach the uprights to
each black corner piece, Fig.11. Use the x4 black knobs to
position the sliding trapeze frame and the roll down bar frame in
place. These simply screw in as per Fig.12.
Fig. 12
4