AEG 6000 Series Manual do utilizador - Página 8

Procurar online ou descarregar pdf Manual do utilizador para Forno AEG 6000 Series. AEG 6000 Series 24 páginas.
Também para AEG 6000 Series: Manual do utilizador (12 páginas), Manual do utilizador (24 páginas), Manual do utilizador (24 páginas)

Imprimir página

www.aeg.com

3.2 Location

To ensure appliance's best functionality,

you should not install the appliance in the

nearby of the heat source (oven, stoves,

radiators, cookers or hobs) or in a place

with direct sunlight. Make sure that air

can circulate freely around the back of

the cabinet.

3.3 Positioning

This appliance should be installed in a

dry, well ventilated indoor position.

This appliance is intended to be used at

ambient temperature ranging from 10°C

to 43°C.

The correct operation of the

appliance can only be

guaranteed within the

specified temperature range.

If you have any doubts

regarding where to install the

appliance, please turn to the

vendor, to our customer

service or to the nearest

Authorised Service Centre.

It must be possible to

disconnect the appliance

from the mains power

supply. The plug must

therefore be easily

accessible after installation.

3.4 Electrical Connection

CAUTION!

Any electrical work required

to install this appliance

should be carried out by a

qualified electrician or

competent person.

WARNING!

This appliance must be

earthed.

The manufacturer declines

any liability should these

safety measures not be

observed.

The wires in the mains lead are coloured

in accordance with the following code:

• A - green and yellow: Earth

• C - brown: Live

• D - blue: Neutral

As the colours of the wires in the mains

lead of this appliance may not

correspond with the coloured markings

identifying the terminals in your plug,

proceed as follows:

1. Connect the wire coloured green and

yellow to the terminal marked either

with the letter "E" or by the earth

symbol

or coloured green and

yellow.

2. Connect the wire coloured blue to the

terminal either marked with the letter

"N" or coloured black.

3. Connect the wire coloured brown to

the terminal either marked with the

"L" or coloured red.

4. Check that no cut, or stray strands of

wire is present and the cord clamp

(E) is secure over the outer sheath.

Make sure the electricity supply

voltage is the same as that indicated

on the appliance rating plate.

5. Switch on the appliance.

The appliance is supplied with a 13 amp

fuse (B). In the event of having to change

the fuse in the plug supplied, a 13 amp

ASTA approved (BS 1362) fuse must be

used.