Garmin 400W Series Manual - Página 16
Procurar online ou descarregar pdf Manual para GPS Garmin 400W Series. Garmin 400W Series 22 páginas. Bell 206b
Também para Garmin 400W Series: Manual de voo suplementar (16 páginas), Adenda ao Manual do Piloto (24 páginas), Suplemento ao manual (14 páginas), Adenda ao Manual do Piloto (50 páginas), Manual de referência rápida (25 páginas), Manual de instruções (26 páginas)
Imprimir página
Alert Text
Not receiving input data on
232 Channel #(1 through 5)
Not receiving traffic data
OBS key stuck
OBS not available
Obstacle database integrity
error
RAIM position warning
Searching the sky
Stored data was lost
TERRAIN configuration
conflict
TERRAIN configuration has
changed
Terrain database integrity
error
400W Series
Instructions for Continued Airworthiness Bell 206B
Possible Cause
• No data has been received on
one (or more) of the RS-232
channel connections for a
period exceeding ten seconds.
• No traffic data is being
received.
• The OBS key is stuck in the
enabled (or pressed) state.
Try pressing the OBS key
again to cycle its operation.
• No destination waypoint has
been selected.
• The GPS receiver cannot
currently determine its position.
• The 400W Series unit has
detected a problem with a
database on the Terrain data
card.
• Although sufficient GPS
satellite coverage may exist,
Receiver Autonomous Integrity
Monitoring (RAIM) has
determined the information
from one or more GPS
satellites may be in error.
• The 400W Series unit is
searching the sky for GPS
satellites.
• All user waypoints, flight plans
and system settings have been
lost due to a memory battery
failure or system reset.
• The current Terrain
configuration is not supported
by the hardware.
• The unit's terrain settings
have changed since it was
last turned on in normal
mode.
• The 400W Series unit has
detected a problem with a
database on the Terrain data
card.
Solution
• Refer to Table 6-1 "RS-232
device is not communicating
with the
GPS400W/GNC420W/GNS430
W"
• Check for proper configuration
• Check the wiring
• Contact Garmin technical
support.
• Contact Garmin technical
support.
• Select a waypoint
• Refer to Error! Reference
source not found."The 400W
Series unit does not compute a
position."
• The data is not usable. Try
reloading the information onto
the card. If that does not solve
the problem replace the card.
• Wait for GPS satellite geometry
to improve.
• Wait 20 minutes for unit to
complete cycle or until the
current position is located.
• If system was not reset replace
the battery.
• Reconfigure the unit.
• Reconfigure TERRAIN settings
• Contact Garmin technical
support
• Reloading the information onto
the card.
• Replace the card.
190-01226-04 Rev. 2
Page 16 of 22