2.12 Special Tools
A milliohm meter with an accuracy of +/- 0.1 milliohms ohms (or better) is required to measure the
electrical bonding between the 500W system components and aircraft ground.
No special tools are required for system checkout. See 500W Series Installation Manual listed in
reference documentation in section 2.1 of this document.
2.13 Additional Instructions
None.
2.14 Overhaul Period
The system does not require overhaul at a specific time period. Power on self-test and continuous BIT
will monitor the health of the 500W series unit. If the unit indicates an internal failure, the unit may be
removed and replaced. See troubleshooting section contained in the 500W Series Installation Manual,
listed under reference documentation in section 2.1 of this document.
2.15 ICA Revision and Distribution
To revise this ICA, Garmin will follow the Garmin ODA Procedures Manual SOP-0055/ACP-0016 for
Instructions for Continued Airworthiness. The latest revision of this ICA document is available on the
Garmin Dealer Resource Center (www.garmin.com). A Garmin Service Bulletin describing ICA revision
will be sent to Garmin dealers if a revision is determined to be significant.
2.16 Assistance
Flight Standards Inspectors or the certificate holder's PMI have the required resources to respond to
questions regarding this ICA. In addition, the customer may refer questions regarding this equipment and
its installation to the manufacturer, Garmin. Garmin customer assistance may be contacted during
normal business hours via telephone 913-397-8200 or email from the Garmin web site at
www.garmin.com.
2.17 Implementation and Record Keeping
Modification of an aircraft by this Supplemental Type Certificate obligates the aircraft operator to include
the maintenance information provided by this document in the operator's aircraft maintenance manual
and/or the operator's aircraft scheduled maintenance program.
500W Series
190-00357-65 Rev. D
Instructions for Continued Airworthiness
Page 11 of 12
Imprimir página