Brother 885-X03 Manual de operação - Página 24

Procurar online ou descarregar pdf Manual de operação para Máquina de costura Brother 885-X03. Brother 885-X03 48 páginas.
Também para Brother 885-X03: Manual de operação (48 páginas), Manual de operação (48 páginas)

Imprimir página
Brother 885-X03 Manual de operação
SEWING BASICS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
While holding the end of the thread and
7
the fabric with your left hand, turn the
handwheel toward you
(counterclockwise) with your right hand
to lower the needle to the starting point of
the stitching.
Lower the presser foot lever.
8
1 Presser foot lever
Slowly press down on the foot controller.
9
The machine starts sewing.
Take your foot off the foot controller.
0
The machine stops sewing.
• You can use reverse sewing for back tacking
and reinforcing seams by pressing the reverse
sewing lever. Refer to "Reverse sewing lever"
on page 11 for the details.
Raise the needle by turning the
a
handwheel toward you
(counterclockwise).
Raise the presser foot lever.
b
Pull the fabric to the left side of the
c
machine, and then pass the threads
through the thread cutter to cut them.
.
1
1 Thread cutter
23
1

Trial sewing

A trial piece of fabric should be sewn. Use a piece of
fabric and thread that are the same as those used for
your project, and check the thread tension and stitch
length and width.
Changing the sewing
direction
Stop the machine with the needle in the fabric at the
point where you want to change the sewing direction,
and then raise the presser foot lever. Using the needle
as a pivot, turn the fabric, lower the presser foot lever,
and then continue sewing.

Sewing thick fabrics

■ If the fabric does not fit under the presser
foot
If the fabric does not fit easily under the presser foot,
raise the presser foot lever even higher to bring the
presser foot to its highest position.
CAUTION
●
If fabric more than 6 mm (15/64 inch)
thick is sewn or if the fabric is pushed
with too much force, the needle may
bend or break.
1
2