Brother 885-X13 Manual de operação - Página 27

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Start sewing.

6

For details on starting to sew, refer to "Starting

sewing" on page 22.

Two lines of stitching are sewn parallel to

each other.

Note

● When using the twin needle, the stitches

may become bunched together, depending

on the types of thread and fabric that are

used. If this occurs, increase the stitch

length. For details on adjusting the stitch

length, refer to "Stitch length dial" on

page 11.

CAUTION

●

When changing the sewing direction, be

sure to raise the needle from the fabric,

and then raise the presser foot lever and

turn the fabric. Otherwise the needle

may break or the machine may be

damaged.

The tension of the thread will affect the quality of your

stitches. You may need to adjust it when you change

fabric or thread.

Memo

● We recommend that you do a test sample

on scrap of a fabric before you start to sew.

■ Correct tension

Correct tension is important as too much or too little

tension will weaken your seams or cause puckers

on your fabric.

2

1

3

1 Surface of fabric

2 Back of fabric

3 Upper thread

4

4 Lower thread

■ Upper tension is too tight

Loops will appear on the surface of the fabric.

Note

● If the bobbin thread was incorrectly

threaded, the upper thread may be too tight.

In this case, refer to "Lower threading" on

page 14 and rethread the bobbin thread.

2

1

3

5

4

Solution

Reduce the tension by turning the upper tension

control dial to a lower number.

■ Upper tension is too loose

Loops appear on the back of the fabric.

Note

● If the upper thread was incorrectly threaded,

the upper thread may be too loose. In this

case, refer to "Upper threading" on page 16

and rethread the upper thread.

5

2

1

3

4

Solution

Increase the tension by turning the upper tension

control dial to a higher number.

1 Surface of fabric

2 Back of fabric

3 Upper thread

4 Lower thread

5 Loops appear on

surface of fabric

1 Surface of fabric

2 Back of fabric

3 Upper thread

4 Lower thread

5 Loops appear on back

of fabric

26

2