Garmin Zumo 395 Manual do Proprietário - Página 5

Procurar online ou descarregar pdf Manual do Proprietário para Sistema de navegação automóvel Garmin Zumo 395. Garmin Zumo 395 26 páginas.
Também para Garmin Zumo 395: Manual de início rápido (20 páginas), Manual de instruções de instalação (46 páginas)

Imprimir página
Garmin Zumo 395 Manual do Proprietário

Installation

Mounting Your Device in a Motorcycle
Powered Motorcycle Mount
Garmin
strongly recommends having an experienced installer
®
with the proper knowledge of electrical systems install the
device. Incorrectly wiring the power cable can result in damage
to the vehicle or the battery and can cause bodily injury.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
The device must be mounted in a suitable and secure location
on your motorcycle, based on available power sources and safe
cable routing.
Motorcycle cradle
12 to 24 Vdc system power (red) with in-line fuse
System ground (black)
Installing the Handlebar Base
The device includes parts for two handlebar installation
solutions. Custom mounts may require additional hardware.
Installing the U-bolt and Handlebar Base
1
Place the U-bolt
around the handlebar
ends through the handlebar base
2
Tighten the nuts to secure the base.
NOTE: The recommended torque is 50 lbf-in (5.65 N-m). Do
not exceed torque of 80 lbf-in (9.04 N-m).
Installing the Handlebar Base to the Clutch-Clamp or Brake-
Clamp Brackets
1
Remove the two factory bolts on your clutch-clamp or brake-
clamp bracket
.
Installation
WARNING
, and thread the
.
NOTE: Both 1/4 in. standard and M6 bolts are included.
Match the size of the factory bolts on your clutch-clamp or
brake-clamp bracket.
2
Thread the new bolts
, and clutch-clamp or brake-clamp bracket.
3
Tighten the bolts to secure the base.
Attaching the Power Cables to the Motorcycle Mount
1
Thread the power cable connector
opening in the motorcycle mount.
2
Slide the cable down to the bottom of the opening
the cable back until it is snug.
3
Screw the black screw
hold the cable in place.
4
Thread the weather cap
into the hole.
through the handlebar base, spacers
through the top of the
into the back of the mount
through the top hole and press it
and pull
to
1