1. MOUSE CLICKING AREAS
1. ON / OFF KEY.
2. AUDIO NAV SIGNAL KNOB.
3. Large left knob: TUNE RADIO NAV OR COM WHOLE FIGURES.
4. Press small left knob: TOGGLE TUNNING NAV COM RADIOS.
5. Small left knob: TUNE RADIO NAV OR COM FRACTAL FIGURES.
6. The GNS 430's CDI Key is used to couple the GPS or VLOC receiver to the external
CDI (or HSI). When the external CDI (or HSI) is being driven by the GPS receiver,
'GPS' appears at the bottom left corner of the page, directly above the CDI Key. When
the external CDI (or HSI) is being driven by the VLOC receiver, 'VLOC' appears
instead. To couple the external CDI (or HSI) to the GPS receiver or VLOC receiver,
press the CDI Key to display 'GPS' or 'VLOC', as desired.
7. The OBS Key is used to select manual or automatic sequencing of waypoints. Pressing
the OBS Key selects OBS mode, which retains the current 'active to' waypoint as the
navigation reference even after passing the waypoint (i.e., prevents sequencing to the
next waypoint). By pressing the OBS Key again the unit is sent back to normal
operation mode, with automatic sequencing of waypoints.
8. The MSG Key is used to view system messages.
9. The FPL Key allows the pilot to see flight plans. Flight plans must be created by FS9 or
add-ons methods. This version doesn't allow you to create flight plans.
10. The PROC Key allows the pilot to select approaches from the flight plan. When using a
flight plan, available procedures for the arrival airport are offered automatically.
11. Small right knob: These areas are used to select among the various pages within one of
the groups available. When entering data, the small knob is used to select the desired
letter or number and the large knob is used to move to the next character space. The
small right knob is also used to move up or down when the map panning function is
active.
12. Pressing small right knob actives cursor or map panning if GPS is in map mode.
13. Large right knob: These areas are used to select among the various page groups: NAV,
WPT, NRST or AUX. With the on-screen cursor enabled, the large right knob allows the
pilot to move the cursor about the page. The large right knob is also used to move right
or left when the map panning function is active.
14. The CLR Key is used to erase information or to cancel an entry. Press and hold the
CLR key to immediately display the Default NAV Page.
15. The ENT Key is used to approve an operation or complete data entry.
16. The Direct-to Key provides access to the direct-to function, which allows the pilot to
select a destination waypoint and establishes a direct course to the selected
destination.
Imprimir página