Garmin echomap 40 series Manual do Piloto - Página 14

Procurar online ou descarregar pdf Manual do Piloto para Sistema GPS marítimo Garmin echomap 40 series. Garmin echomap 40 series 22 páginas. Vhf comm
Também para Garmin echomap 40 series: Manual de instruções de instalação (15 páginas), Manual do Proprietário (32 páginas), Declaração de Conformidade (1 páginas), Manual do Proprietário (30 páginas), Manual do Proprietário (50 páginas)

Detailed Operation

Getting Started

Intercom and Stuck Mic

119.10 *s 121.50

Intercom Function is Selected

Stuck Mic Message

6. Press MEM to save the displayed ID. Turn the Large knob to "Done" and press MEM.

The alphanumeric ID for a frequency is displayed only when looking at user stored frequencies using

the recall (RCL) feature. The stored frequency is displayed numerically once selected as the active or

standby frequency.

You can remove the ID for a frequency while retaining the frequency in User memory by setting all

characters to underscores and pressing MEM.

Intercom Function

When two headphone and microphone jacks are connected to the SL40, these headsets can be used

as a voice-activated intercom.

When you select the Intercom function with the installed selector switch, the intercom function is en-

abled. The Volume control will control the headphone listening level. The receive function will automati-

cally become active when a signal is detected, but the volume will be reduced during intercom activity.

A small "I" is displayed above and to the left of the "s" or "m" of the standby frequency to indicate the

Intercom function is selected.

The Microphone Squelch Sensitivity can be set in the System Functions.

Stuck Mic

The SL40 helps protect you from a situation where the microphone may get stuck in the ON or Trans-

mit position. If the microphone is keyed for longer than 35 seconds, the SL40 will return to the receive

mode on the selected frequency.

A ﬂashing "Stuck Mic" message will display until the transmit key is released.

Note: In an emergency situation, if the "Stuck Mic" message remains after you have stopped

keying the mic, turn the power off and then back on. You will then get another 35 second time-

out period to transmit.