GHP
10 Marine Autopilot System Installation Instructions
™
To obtain the best possible performance and to avoid damage to your boat, install the Garmin
GHP 10 marine autopilot system
®
according to the following instructions. Professional installation of the autopilot system is highly recommended. Specific training in
hydraulic pipe-fitting and in marine electrical connections is required to properly install the autopilot system.
Read all installation instructions before proceeding with the installation. If you experience difficulty during the installation,
contact Garmin Product Support.
note: If your boat uses a Mercury
Verado
engine, you must also purchase a Mercury Verado Adapter Kit (Garmin part number
®
®
010-11202-00). Contact your local Garmin dealer or Garmin Product Support for ordering information.
Product Registration
Help us better support you by completing our online registration today. Go to http://my.garmin.com. Keep the original sales receipt, or
a photocopy, in a safe place.
For future reference, write the serial number assigned to each component of your GHP 10 system in the spaces provided on
page
2.
The serial numbers are located on a sticker on each component.
Contact Garmin
Contact Garmin Product Support if you have any questions while installing your GHP 10. In the USA, go to
www.garmin.com/
support, or contact Garmin USA by phone at (913) 397.8200 or (800) 800.1020.
In the UK, contact Garmin (Europe) Ltd. by phone at 0808 2380000.
Contact Support
In Europe, go to
www.garmin.com/support
and click
for in-country support information, or contact Garmin
(Europe) Ltd. by phone at +44 (0) 870.8501241.
WARnInGS
You are responsible for the safe and prudent operation of your vessel. The GHP 10 is a tool that will enhance your capability to
operate your boat. It does not relieve you from the responsibility of safely operating your boat. Avoid navigational hazards and never
leave the helm unattended.
Always be prepared to promptly regain manual control of your boat.
Learn to operate the GHP 10 on calm and hazard-free open water.
Use caution when operating the GHP 10 at high speeds near hazards in the water, such as docks, pilings, and other boats.
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
CAutIon
Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
Notice
When drilling or cutting, always check the opposite side of the surface. Be aware of fuel tanks, electrical cables, and hydraulic hoses.
February 2010
190-01166-02 Rev. B
Printed in Taiwan
Imprimir página