Garmin GPS 17 Series Manual de instruções de instalação - Página 6
Procurar online ou descarregar pdf Manual de instruções de instalação para Sistema GPS marítimo Garmin GPS 17 Series. Garmin GPS 17 Series 16 páginas. Technical specifications
Também para Garmin GPS 17 Series: Manual de instruções de instalação (17 páginas), Manual de instruções de instalação (19 páginas), Especificações técnicas (37 páginas)
Imprimir página
I
I
NSTALLATION
NSTRUCTIONS
Installing the GPS 17
You can install flush mount or install the GPS 17 on any standard 1" O.D. (Outer
Dimension), 14 threads-per-inch marine mount. When mounting the GPS 17, the
cable can be run externally, through the mounting panel, or through the center of
the marine mount.
The GPS 17 connects to the 18-pin Power/Data Cable on the
GPSMAP 2106/2110 and provides the GPS/WAAS signal for the unit. If two
or more GPSMAP 2106/2110 units are installed, only one GPS 17 needs to be
installed.
To ensure the best reception, mount the GPS 17 in a location that has a clear,
unobstructed view of the sky in all directions. Avoid mounting the GPS 17 where
it is shaded by the boat's superstructure, a radome antenna, or mast. Sailboat
users should avoid mounting the unit high on the mast to prevent inaccurate speed
readings caused by excessive heeling. The unit provides more stable readings if
it is located nearer to water level. Mount the GPS 17 at least 3 ft away from
(preferably above) the path of any radar beam or a VHF radio antenna.
Temporarily secure the unit in the preferred mounting location and test for
correct operation. With correct operation verified, permanently mount the unit. If
interference with other electronics is experienced, try a different location.
NOTE: Never paint the GPS 17 or clean it with harsh solvents.
To flush mount the GPS 17:
1. Cut out the Flush Mount Drilling Template provided on page 13, and tape it on the selected mounting location.
2. Mark the center of each mounting hole by tapping the end of a center punch or pointed object with a hammer. If the cable is going to be
installed through the mounting panel, mark the center of the additional hole.
3. Drill the holes using the appropriate drill bits.
4. Align the GPS 17 over the mounting holes and fasten it using M4 screws. The mounting threads in the GPS 17 are 8.10 mm deep. Do
not use screws that thread into the GPS 17 deeper than 8 mm, or the case may be damaged.
The GPS 17 can be installed with the coax through the panel
or on the outside of the unit. If the coax is run through the
panel, seal the outside exit area with marine sealant.
4
ABOVE - BEST
Radar
BELOW - OK
Radar
NOTE: Mount the antenna at least 3 ft away from
(preferably above) the path of any radar beam or a
VHF radio antenna.
EMI
EMI (Electromagnetic Interference)
from engine components
Signal Interference
Mounting holes
Bottom of GPS 17
3'
VHF Radio Antenna
BETTER
BEST
GOOD
GPSMAP 2106/2110 & GPS 17