Garmin 010-02346-00 Manual de instruções de instalação - Página 2

Procurar online ou descarregar pdf Manual de instruções de instalação para Equipamento marítimo Garmin 010-02346-00. Garmin 010-02346-00 19 páginas.

Mounting Considerations

In high ambient temperatures and after extended use, the device enclosure may reach temperatures deemed

dangerous to touch. As a result, the unit must be installed in a location where it cannot be touched during

operation.

This device should be mounted in a location that is not exposed to extreme temperatures or conditions. The

temperature range for this device is listed in the product specifications. Extended exposure to temperatures

exceeding the specified temperature range, in storage or operating conditions, may cause device failure.

Extreme-temperature-induced damage and related consequences are not covered by the warranty.

When selecting a mounting location for the device, observe these considerations.

• You must mount the device in a location where it is not submerged.

• You must mount the device in a location with adequate ventilation where it is not exposed to extreme

temperatures.

• You should mount the device so the cables can be connected easily.

• To achieve IPX2 water ingress protection, you must mount the device on a vertical surface with the

connectors pointing downward.

• You can mount the device on a horizontal surface, but such positioning might not achieve IPX2 water ingress

protection.

• To avoid interference with a magnetic compass, you must mount the device at least 15 cm (6 in.) away from

a compass.

If you are mounting the device in fiberglass, when drilling the pilot holes, use a countersink bit to drill a

clearance counterbore through only the top gel-coat layer. This will help to avoid cracking in the gel-coat layer

when the screws are tightened.

NOTE: Screws are included with the device, but they may not be suitable for the mounting surface.

Before you mount the device, you must select a mounting location, and determine what screws and other

mounting hardware are needed for the surface.

1 Place the device in the mounting location, and mark the location of the pilot holes.

2 Drill a pilot hole for one corner of the device.

3 Loosely fasten the device to the mounting surface with one corner, and examine the other three pilot-hole

marks.

4 Mark new pilot-hole locations if necessary, and remove the device from the mounting surface.

5 Drill the remaining pilot holes.

6 Secure the device to the mounting location.

For the stereo to function correctly, you must connect it to power, to speakers, and to input sources. You should

carefully plan the layout of the stereo, speakers, input sources, optional NMEA 2000 network, and optional

Fusion PartyBus

devices or network before making any connections.

™

CAUTION

NOTICE

Apollo MS-WB670 Installation Instructions