Garmin FUSION Apollo MS-WB670 Manual do Proprietário - Página 31
Procurar online ou descarregar pdf Manual do Proprietário para Equipamento marítimo Garmin FUSION Apollo MS-WB670. Garmin FUSION Apollo MS-WB670 44 páginas. Marine hideaway stereo
Também para Garmin FUSION Apollo MS-WB670: Manual de instruções de instalação (19 páginas)
Imprimir página
Maintaining Individual Zone Volume Levels
If you adjust the volume levels of individual zones so that some zones are louder than others, the individual
zone volume settings are all affected when you adjust the volume for ALL zones. By default, if you adjust the
volume for ALL to 00, this sets of the volume levels for all zones to 00 and resets all individual zone volume
adjustments. You can enable the KEEP VOLUME RATIOS option to retain individual zone volume adjustments
when you adjust the volume for ALL to 00.
NOTE: This setting applies to volume adjustments on the stereo or a connected Apollo ERX400 remote control
only. If you adjust the volume on the stereo using a connected chartplotter or NRX remote control, the volume
levels will still be reset.
TIP: For the best results when enabling this setting, you should set the power-on volume limit to 24
the Power-On Volume Limit, page
1 Select
> SETTINGS.
2 Select the name of the remote control.
3 Select KEEP VOLUME RATIOS.
Enabling Automatic Volume Adjustment Based on Speed
1 Select
> SETTINGS.
2 Select the name of the stereo.
3 Select ZONE > SPEED VS VOLUME > ENABLED
4 If needed, update the settings to select the speed source
Automatic Volume Control Settings
Select
> SETTINGS, select the name of the stereo, then select ZONE > SPEED VS VOLUME.
ENABLED: Enables the automatic volume control feature.
SPEED SOURCE: Sets the source that the stereo uses to determine the speed
page
26).
MAX/MIN SPEED: Sets the expected maximum and minimum speed range for the selected SPEED SOURCE.
The MIN setting indicates the speed at which the volume plays at the level you set by turning the dial. The
MAX setting indicates the speed at which the volume plays at the highest level set in the VOLUME
INCREASE setting.
TIP: You should start by setting these values at the speeds you typically expect from your engine or sensor
and adjust them as needed.
VOLUME INCREASE: Sets the total volume increase for each zone when the selected SPEED SOURCE
reaches the set maximum speed set in the MAX/MIN SPEED setting. The higher you set this level, the
louder the volume will be as you approach the set maximum speed.
NOTE: When the volume increases to adjust for speed, the actual volume output changes but the volume-
level indicator bar and number stays the same.
CUSTOM UNITS: Changes the measurement unit used to indicate the vessel or wind speed.
General Settings
24).
(Automatic Volume Control Settings, page
(Speed Source Information,
(Adjusting
25).
25