Garmin FUSION XS Series Manual de instruções de instalação - Página 4

Procurar online ou descarregar pdf Manual de instruções de instalação para Equipamento marítimo Garmin FUSION XS Series. Garmin FUSION XS Series 13 páginas. Marine wake tower speakers
Também para Garmin FUSION XS Series: Manual de instruções de instalação (11 páginas), Manual de instruções de instalação (6 páginas), Instruções de instalação (4 páginas), Manual de instruções de instalação (6 páginas)

Mounting the Subwoofer

Before mounting the subwoofer, you must choose a location following the mounting considerations above.

Before cutting the mounting surface, you should verify that there is enough clearance for the speaker behind the

surface. Refer to the specifications for clearance information.

Do not apply grease or lubricant to the screws when fastening the subwoofer to the mounting surface. Grease

or other lubricants can cause damage to the subwoofer housing.

1 Route the wires from the source to the mounting location, away from sources of electrical interference.

2 Trim the template and make sure it fits in the selected location.

3 Orient the template so the FUSION logo is level in the selected location.

4 Secure the template to the selected location.

5 Using a rotary tool or jigsaw, cut the mounting surface along the inside of the line on the template.

6 Place the subwoofer in the cutout to test the fit.

7 If necessary, use a file and sandpaper to refine the size of the cutout.

8 After the subwoofer fits correctly in the cutout, ensure the mounting holes on the subwoofer line up with the

pilot holes on the template.

9 If the mounting holes on the subwoofer do not line up, mark the new hole locations.

10 Using an appropriately sized drill bit for the mounting surface and screw type, drill the holes.

11 Remove the template from the mounting surface.

12 Connect the subwoofer wires

13 If necessary, connect the LED wires to the Sports model subwoofer

14 Place the subwoofer in the cutout.

15 Secure the subwoofer to the mounting surface using the included screws

NOTE: Do not over tighten the screws, especially if the mounting surface is not flat.

16 With the subwoofer mounted, hold the grille with the FUSION logo at the bottom, or at the 6 o'clock position.

17 Press on the grille to snap it into place.

NOTICE

while observing polarity

(Subwoofer Wiring, page

(LED Wiring, page

XS Series Subwoofer Installation Instructions

5).