AEG FAVORIT 40 Informações do utilizador - Página 27
Procurar online ou descarregar pdf Informações do utilizador para Máquina de lavar loiça AEG FAVORIT 40. AEG FAVORIT 40 44 páginas. Aeg dishwasher
Imprimir página
What to do if...
Remedying small malfunctions
If one of the following fault codes is displayed in the multi-display dur-
ing operation:
– Fault codeÅ 10 (Problems with water inlet),
– Fault codeÅ 20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the cycle that has
started. The cycle will continue.
With other fault codes ("Å " followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact the Customer Care De-
partment and inform them of the fault code.
Malfunction
The cycle indicator for the
selected dishwashing cycle
is flashing:
Å 10
fault code
played in the multi-dis-
play:
(Problems with water in-
let)
The cycle indicator for the
selected dishwashing cycle
is flashing,
Å 20
fault code
played in the multi-dis-
play.
(Problems with water
drainage)
Possible cause
Water tap is blocked with
limescale or faulty.
The tap is turned off.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
is dis-
Filters in the base of the
dishwasher compartment
are blocked.
Water inlet hose
has not been correctly posi-
tioned.
The sink outlet is blocked.
is dis-
Water drain hose
has not been correctly posi-
tioned.
Remedy
Check the water tap and
have it repaired if necessary.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Cancel the dishwashing cy-
cle (see chapter: Starting a
dishwashing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing
cycle again.
Check the position of the
hose.
Clean out sink outlet.
Check the position of the
hose.
27