Garmin Panoptix Livescope Manual de instruções de instalação - Página 2
Procurar online ou descarregar pdf Manual de instruções de instalação para Equipamento marítimo Garmin Panoptix Livescope. Garmin Panoptix Livescope 6 páginas.
Imprimir página
Installing the Transducer on a Trolling Motor
You must secure the transducer cable to the shaft or other
secure location during installation. Damage to the transducer
cable wires or cable jacket can cause transducer failure.
1
Insert the hose clamp
mount
until equal lengths extend on both sides of the
mount.
2
Secure the hose clamp around the trolling motor
NOTE: Do not rotate the transducer.
3
Secure the transducer cable to the motor shaft or other
secure location.
4
Route the transducer cable to the installation location of the
sonar module while taking these precautions.
• You should not route the cable close to electrical wires or
other sources of electrical interference.
• You must route the cable so it is not pinched when the
trolling motor is deployed or stowed.
NOTE: If necessary, for extra cable length you can connect
an optional extension cable, available at
from your Garmin dealer.
5
Position the transducer to your desired angle
Mount Orientation, page
Trolling Motor Mount Orientation
The orientation depends on which side of the trolling motor you
have mounted the transducer on, and your desired field of view.
TIP: No tools are necessary to change the orientation from
forward to down. Turn the mount one click to change the
orientation from forward to down.
Starboard side, forward view
Starboard side, downward view
Port side, forward view
Port side, downward view
2
NOTICE
through the slot on the trolling motor
buy.garmin.com
(Trolling Motor
2).
Installing the Transducer on a Trolling Motor
Shaft
Trolling Motor Shaft Bracket Orientation
The trolling motor shaft bracket features an 8-degree cant to
reduce the effects of the trolling motor barrel interference with
the transducer beam. You must orient the arrow
narrow end of the angle
bracket to the trolling motor shaft.
Assembling the Trolling Motor Shaft Mount Hardware
With the trolling motor bracket oriented correctly
Motor Shaft Bracket Orientation, page
hex wrench to attach the transducer
bracket
rubber washer
NOTE: You must fully tighten the mount to the transducer.
.
The recommended torque applied to the shoulder screw is
2.5 lb-ft. (3.4 N-m).
or
Installing the Transducer on the Trolling Motor Shaft
You must secure the transducer cable to the shaft or other
secure location during installation. Damage to the transducer
cable wire or the cable jacket can cause transducer failure.
You should mount the transducer as far from the motor as
possible.
You should use the included rubber insert on a 25 mm (1 in.)
trolling motor shaft.
1
Using the included hex wrench, insert the M6 screws
attach the shaft trolling bracket
around the trolling motor shaft.
to the top when you attach the
with the shoulder screw
.
NOTICE
to the transducer bracket
and the
(Trolling
2), use the included
to the trolling shaft
, flat washer
, and
and