Garmin GTX 32 Manual de instalação - Página 27

Procurar online ou descarregar pdf Manual de instalação para Rádio marítimo Garmin GTX 32. Garmin GTX 32 45 páginas.

3.7

Post Installation Configuration and Checkout

The GTX 32 Transponder will not provide valid outputs until the aircraft

post installation configuration procedures are completed.

3.7.1 Configuration

When installed as part of a Garmin Integrated Flight Deck, the GTX 32 transponder must have FAA

approved configuration data. Configuration data is loaded to the GTX 32 from an aircraft-specific SW

Loader Card. Transponder settings are predetermined for a specific aircraft and are typically contained

within the file named 'GTX1'.

The GDU PFD serves as the graphics user interface to the installer configuring the system. For basic

configuration information, refer to the G1000 Line Maintenance and Configuration Manual, Garmin part

number 190-00303-04. For actual aircraft installation/checkout, use only aircraft manufacturer approved

checkout procedures.

Verify proper operation of the transponder by testing in accordance with Appendix F to 14 CFR Part 43 –

ATC Transponder Tests and Inspections.

For transponder installations operating with a Garmin GNS 480 (CNX80) system refer to GNS 480

(CNX80) Installation Manual 560-0982-01 for configuration procedures and operation checks.

For transponder installations operating with a Garmin GDL 90 system refer to GDL 90 Installation

Manual 560-1049-02 for configuration procedures and operation checks.

3.7.2 Interference Check

Turn on and verify operation of all avionics equipment except GTX 32. Then power GTX 32 on and

verify there is no interference with any other equipment in the aircraft. The operation/performance

checks should be made with all other avionics turned on. Verify that there is no interference during any

mode of transponder operation.

GTX 32 Installation Manual

190-00303-60

NOTE

Page 3-5

Revision F