Garmin GTX 327 Manual do Piloto - Página 7

Procurar online ou descarregar pdf Manual do Piloto para Rádio marítimo Garmin GTX 327. Garmin GTX 327 8 páginas. Mode a/c transponder
Também para Garmin GTX 327: Manual do Piloto (8 páginas), Manual do Piloto (8 páginas), Manual do Piloto (8 páginas), Manual do Piloto (4 páginas)

Imprimir página
Garmin GTX 327 Manual do Piloto
Altitude Trend Indicator
When the 'PRESSURE ALT' page is displayed, an arrow may be displayed to the right of the
altitude, indicating that the altitude is increasing or decreasing. Of of two sizes of arrows may
be displayed depending on the rate of climb/descent. The sensitivity of these arrows is set
using the GTX 327 Configuration Mode.
Timer Operation
To operate the Flight Timer:
1. Press the FUNC key until 'FLIGHT TIME' is displayed.
2. If the GTX 327 is configured as having a squat switch installed, the timer will begin
counting automatically when the squat switch senses that the aircraft has become
airborne.
3. If desired, you may press START/STOP to pause or restart the timer.
4. Press CLR to reset the timer to zero.
5. If the GTX 327 is configured as having a squat switch installed, the timer will pause
automatically when the squat switch senses that the aircraft has touched down.
To operate the Count Up timer:
1. Press the FUNC key until 'COUNT UP' is displayed.
2. If necessary, press CLR to reset the Count Up timer to zero.
3. Press START/STOP to count up.
4. Press START/STOP again to pause the timer.
5. Press CLR to reset the timer to zero.
To operate the Count Down timer:
1. Press the FUNC key until 'COUNT DOWN' is displayed.
2. Press CRSR and use the 0 - 9 keys to set the initial time. All digits must be entered (use
the 0 key to enter leading zeros).
3. Press START/STOP to count down.
4. Press START/STOP again to pause the timer.
5. When the Count Down timer expires, the words 'COUNT DOWN' are replaced with
'EXPIRED', and the time begins counting up and flashing.
6. Press CLR to reset the timer to the initial time value.
Automatic ALT/STBY Mode Switching
If the GTX 327 is configured for automatic standby switching, the mode will automatically
change to ALT when a squat switch senses that the aircraft has become airborne. Also, the
mode will change to STBY automatically when a squat switch senses that the aircraft has
touched down. Additionally, a delay time can be set in the Configuration Mode, causing the
GTX 327 to wait a specified length of time after landing before automatically changing to STBY
mode.