Garmin Delta Upland Manual do Proprietário - Página 11
Procurar online ou descarregar pdf Manual do Proprietário para Produtos para animais de estimação Garmin Delta Upland. Garmin Delta Upland 14 páginas. Instructions
Também para Garmin Delta Upland: Instruções (4 páginas)
Imprimir página
battery exposure to extreme heat, store the device out of direct
sunlight.
Do not use a sharp object to remove batteries.
Contact your local waste disposal department to properly
recycle the batteries.
Delta Upland Handheld Device Components
Security screws
Back plate
Battery
Battery connector
Gasket
Replacing the Delta Upland Handheld Device Battery
Before you replace the battery, you must remove all dirt, water,
and debris from the device. You also need the security
screwdriver included with the new battery.
You can purchase a replacement battery at
http://buy.garmin.com. You should use only an official Garmin ®
replacement part.
1
Remove the six security screws from the back of the device.
2
Lift up the back plate.
3
Grip the battery connector wires close to the connector, and
pull the connector parallel to the circuit board to disconnect
the battery connector from the device.
4
Remove the old battery from the back plate, noting the
orientation of the battery.
The battery fits tightly. It may be necessary to pry the battery
out of the back plate using a non-sharp, non-metal object.
5
Install the new battery into the back plate with the label side
up, using the same orientation as the old battery.
6
With the new battery, connect the battery connector to the
device.
When properly installed, the connector plug snaps into the
port.
7
Verify the gasket is not damaged and is completely seated in
the groove.
8
Hold the back plate and the device firmly together, and
replace all six security screws without tightening.
9
Verify the back plate and the device are aligned with no
gaps.
10
Tighten the screws evenly.
Device Information
CAUTION
Delta Upland Dog Collar Device Components
Battery assembly
Gasket
Battery connector
Device
Security screws
Replacing the Delta Upland Dog Collar Device Battery
Assembly
Before you replace the battery, you must remove all dirt, water,
and debris from the device. You also need the security
screwdriver included with the new battery.
You can purchase a replacement battery assembly at
http://buy.garmin.com. You should use only a certified Garmin
replacement part. The battery assembly includes a pre-
assembled back plate with a gasket, battery, and battery
connector.
1
Remove the four security screws from the corners of the
device.
2
Lift up the battery assembly.
3
Grip the battery connector wires close to the connector, and
pull the connector outward from the circuit board to
disconnect the battery connector from the device.
4
With the new battery assembly, connect the battery
connector to the device.
When properly installed, the connector plug snaps into the
port and the top face of the connector plug is flush with the
edges of the port.
5
Verify the gasket is not damaged and is completely seated in
the groove.
6
Hold the battery assembly and the device firmly together,
and replace all four security screws without tightening.
7
Verify the battery assembly and the device are aligned with
no gaps.
8
Tighten the screws evenly.
Replacing the Beeper Battery
Before you can replace the battery, you must have a Phillips-
head screwdriver and a CR123A lithium battery.
1
Using a Phillips-head screwdriver, remove the screw
the battery cover
.
from
7