Fujitsu ABT24UB Manual de instruções - Página 17
Procurar online ou descarregar pdf Manual de instruções para Ar condicionado Fujitsu ABT24UB. Fujitsu ABT24UB 20 páginas. Floor console/under ceiling dual type
Também para Fujitsu ABT24UB: Manual de instruções (20 páginas)
Imprimir página
OPERATING TIPS
AUTO Restart
In Event of Power Interruption
G Should the power supply to the air conditioner be inter-
rupted by a power failure, the air conditioner will restart
automatically in the previously selected mode once the
power is restored.
G Should a power failure occur during TIMER operation, the
timer will be reset and the unit will begin (or stop) oper-
ating under the new timer setting. In this event, the TIMER
indicator lamp (green) will flash (see page. 4).
Temperature and Humidity Range
COOLING/DRY MODE
COOLING MODELS
HEAT & COOL
MODELS
(Reverse Cycle)
*HEATING MODE
HEAT & COOL
MODELS
(Reverse Cycle)
G If the air conditioner is used under higher temperature conditioner than those listed, the built-in protection circuit may
operate to prevent internal circuit damage. Also, during Cooling and Dry modes, if the unit is used under conditions of lower
temperature than those listed above, the heat-exchanger may freeze, leading to water leakage and other damage.
G Do not use this unit for any purposes other than the Cooling, (*)Heating, Dehumidifying, and air-circulation of rooms in
ordinary dwellings.
Outdoor
Outdoor
Unit
Temperature
AOT18FN
About 21 to 43 °C
AOT24FN
AOT18UN
About 0 to 43 °C
AOT24UN
Outdoor
Outdoor
Unit
Temperature
AOT18UN
About –6 to 24 °C
AOT24UN
G Use of other electrical appliances (electric shaver, etc.) or
nearby use of a wireless radio transmitter may cause the
air conditioner to malfunction. In this event, temporarily
disconnect the power supply plug, reconnect it, and then
use the remote control unit to resume operation.
Temperature
About 18 to 32 °C
Indoor
Temperature
About 30 °C or less
Indoor
Humidity
About 80 % or less
If the unit is used for long pe-
riods under high-humidity
conditions, condensation
may form on the surface of
the indoor unit, and drip onto
the floor or other objects un-
derneath.
16