AEG HC411521GB Manual do utilizador - Página 14

Procurar online ou descarregar pdf Manual do utilizador para Hob AEG HC411521GB. AEG HC411521GB 20 páginas.
Também para AEG HC411521GB: Manual do utilizador (24 páginas)

Imprimir página

www.aeg.com

5. If you change:

• from natural gas G20 20 mbar to

liquid gas, fully tighten the bypass

screw in.

• from liquid gas to natural gas G20

20 mbar, undo the bypass screw

approximately 1/4 of a turn.

WARNING!

Make sure the flame does

not go out when you quickly

turn the knob from the

maximum position to the

minimum position.

8.5 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate

agree with the voltage and the power

of the local power supply.

• This appliance is supplied with a

mains cable. It has to be supplied with

a correct plug which can hold the load

that the rating plate rates. Make sure

that you install the plug in a correct

socket.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the

appliance is in connection with an

extension cable, an adapter or a

multiple connection. Make sure that

the ground connection agrees with

the standards and regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

To prevent contact between the cable

and the appliance below the hob use the

clamps which are on the side of the

cabinet.

A. Rigid copper pipe or flexible pipe of

stainless steel

8.6 Connection cable

To replace the connection cable use only

the special cable or its equivalent. The

cable type is: H03V2V2-FT90.

Make sure that the cable section is

applicable to the voltage and the

working temperature. The yellow / green

earth wire must be approximately 2 cm

longer than the brown (or black) phase

wire.

8.7 Assembly