LG - Manual do utilizador - Página 2

Connecting the Monitor

To set up the monitor, ensure that the power is turned off to the monitor,

computer system, and other attached devices, then follow these steps:

Place the monitor in a convenient, well-ventilated location near your computer.

Power off both the monitor and Computer.

Slightly press and pull the latch on Stand cover.

Connect the end of monitor signal cable to the connector

of your monitor throught the slot and cable holder on Stand. Connect the other

end to the 15-pin connector on the rear panel of the computer and tighten the

screws. Be sure the signal cable aligns with the 15-pin connector.

Connect the end of monitor signal cable to the connector

of your monitor throught the slot and cable holder on Stand. Connect the other

end of the monitor signal cable to the rear panel of Macintosh computer

through a Macintosh adapter and then tighten screws.

Connect the plug from the AC adapter into the base of the monitor.

Connect one end of the AC power cord to the AC adapter

end to a properly grounded AC outlet that is easily accessible and close to the

monitor.

After connecting cables, put stand cover correctly into the holes unders stand.

If securely connected, you can hear click sound from the latch.

Power ON the PC, then the monitor.

If you see the NO SIGNAL message, check the signal cable and connectors.

After using the system, power OFF the monitor, then the PC.

IBM PC

MACINTOSH

D-15P

Mac Adapter

D-15P

AC adapter

Signal Cable

* NOTE : If you see the "OUT OF

RANGE" message, check to make

sure your system is set to one of the

factory preset modes.(see page A9)

at the rear panel

and the other

Latch

Stand cover

Power Cord