LG 19M38H Manual do Proprietário - Página 12
Procurar online ou descarregar pdf Manual do Proprietário para Monitor LG 19M38H. LG 19M38H 42 páginas. Ips led monitor
Também para LG 19M38H: Manual do Proprietário (42 páginas), Manual do Proprietário (42 páginas), Manual do Proprietário (42 páginas), Manual do Proprietário (42 páginas), Manual do Proprietário (42 páginas), Manual do Proprietário (42 páginas)
Imprimir página
12
ASSEMBLING AND PREPARING
Mounting on a wall
For proper ventilation, allow a clearance of 100
mm(3.94 inches) on each side and from the wall.
Detailed instructions are available from your
dealer, see the optional Tilt Wall Mounting Bracket
Installation and Setup Guide.
100 mm
(3.94 inches)
100 mm
(3.94 inches)
If you intend to mount the Monitor set to a wall,
attach Wall mounting interface (optional parts) to
the back of the set.
When you install the Monitor set using a wall
mounting interface (optional parts), attach it
carefully so it will not drop.
1
If you use screw longer than standard, the moni-
tor might be damaged internally.
2
If you use improper screw, the product might be
damaged and drop from mounted position.
In this case, LG Electronics is not responsible
for it.
Model
19M38A
19M38D
19M38H
Wall Mount
75 x 75
(A x B)
Standard
M4
screw
Number of
4
screws
Model
24M38A
27MP38VQ
24M38D
27MP38HQ
Wall Mount
100 x 100
(A x B)
Standard
M4
screw
Number of
4
screws
100 mm
(3.94 inches)
100 mm
(3.94 inches)
20M38A
22M38A
20M38D
22M38D
20M38H
22M38H
24M38H
Wall Mount (A x B)
y
CAUTION
Disconnect the power cord first, and then
y
move or install the Monitor set. Otherwise
electric shock may occur.
If you install the Monitor set on a ceiling or
y
slanted wall, it may fall and result in severe
injury.
Use only an authorized LG wall mount
y
and contact the local dealer or qualified
personnel.
Do not over tighten the screws as this may
y
cause damage to the Monitor set and void
your warranty.
Use only screws and wall mounts that
y
meet the VESA standard. Any damages
or injuries by misuse or using an improper
accessory are not covered by the warranty.
Screw length from outer surface of back
y
cover should be under 8mm(0.31 inches).
Wall mount Pad
Wall mount Pad
Back Cover
Standard screw
Max.8mm(0.31 inches)
NOTE
Use the screws that are listed on the VESA
y
standard screw specifications.
The wall mount kit will include an installation
y
manual and necessary parts.
The wall mount bracket is optional. You can
y
obtain additional accessories from your local
dealer.
The length of screws may differ depending
y
on the wall mount. Be sure to use the proper
length.
For more information, refer to the
y
instructions supplied with the wall mount.
Back Cover