LG 20MP48A Manual do Proprietário - Página 13

Procurar online ou descarregar pdf Manual do Proprietário para Monitor LG 20MP48A. LG 20MP48A 44 páginas. Ips led monitor
Também para LG 20MP48A: Manual do Proprietário (45 páginas), Manual do Proprietário (46 páginas), Manual do Proprietário (43 páginas), Manual do Proprietário (43 páginas), Manual do Proprietário (47 páginas), Manual do Proprietário (45 páginas), Manual do Proprietário (43 páginas), Manual do Proprietário (43 páginas), Manual do Proprietário (43 páginas), Manual do Proprietário (43 páginas)

Imprimir página
LG 20MP48A Manual do Proprietário

Mounting on a wall

For proper ventilation, allow a clearance of 10 cm
on each side and from the wall. Detailed
instructions are available from your dealer, see the
optional Tilt Wall Mounting Bracket Installation and
Setup Guide.
10 cm
If you intend to mount the Monitor set to a wall,
attach Wall mounting interface (optional parts) to
the back of the set.
When you install the Monitor set using a wall
mounting interface (optional parts), attach it
carefully so it will not drop.
1
If you use screw longer than standard, the moni-
tor might be damaged internally.
2
If you use improper screw, the product might be
damaged and drop from mounted position.
In this case, LG Electronics is not responsible
for it.
Model
22MP48A
23MP48D
22MP48D
23MP48HQ
22MP48HQ
Wall
75 x 75
Mount (A
x B)
Standard
M4 x L10
screw
Number
4
of screws
Wall
Mount
Plate
(Optional)
10 cm
10 cm
10 cm
RW120
ASSEMBLING AND PREPARING
Wall Mount (A x B)
y
CAUTION
Disconnect the power cord first, and then
y
move or install the Monitor set. Otherwise
electric shock may occur.
If you install the Monitor set on a ceiling or
y
slanted wall, it may fall and result in severe
injury.
Use only an authorized LG wall mount
y
and contact the local dealer or qualified
personnel.
Do not over tighten the screws as this may
y
cause damage to the Monitor set and void
your warranty.
Use only screws and wall mounts that
y
meet the VESA standard. Any damages
or injuries by misuse or using an improper
accessory are not covered by the warranty.
Screw length from outer surface of back
y
cover should be under 8mm.
Wall mount Pad
Wall mount Pad
Back Cover
Standard screw
Max.8mm
NOTE
Use the screws that are listed on the VESA
y
standard screw specifications.
The wall mount kit will include an installation
y
manual and necessary parts.
The wall mount bracket is optional. You can
y
obtain additional accessories from your local
dealer.
The length of screws may differ depending
y
on the wall mount. Be sure to use the proper
length.
For more information, refer to the
y
instructions supplied with the wall mount.
13
Back Cover