AEG 8000 OKOMIX Manual do utilizador - Página 39

Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar roupa AEG 8000 OKOMIX. AEG 8000 OKOMIX 48 páginas.

Imprimir página

Problem

The appliance does not

fill with water properly.

The appliance fills with

water and drains immedi-

ately

The appliance does not

drain the water.

The spin phase does not

operate or the washing

cycle lasts longer than

usual.

There is water on the

floor.

You cannot open the ap-

pliance door.

Possible solution

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the inlet hose has no kinks, damages or

bends.

• Make sure that the connection of the water inlet hose is

correct.

• Make sure that the filter of the inlet hose and the filter of

the valve are not clogged. Refer to 'Care and cleaning'.

• Make sure that the drain hose is in the correct position. The

hose may be positioned too low. Refer to "Installation in-

struction".

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to "Care and cleaning".

• Make sure that the connection of the drain hose is correct.

• Set the drain programme if you set a programme without

drain phase.

• Set the drain programme if you set an option which ends

with water in the tub.

• Set the spin programme.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to "Care and cleaning".

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance prob-

lems.

• Make sure that the couplings of the water hoses are tight

and there is not water leakages.

• Make sure that the water inlet hose and the drain hose have

no damages.

• Make sure you use the correct detergent and the correct

quantity of it.

• Make sure that a washing programme that ends with water

in tub, has been selected.

• Make sure that the washing programme is finished.

• Set the drain or the spin programme if there is water in the

drum.

• Make sure that the appliance receives electrical power.

• This problem may be caused by a failure of the appliance.

Contact the Authorised Service Centre.

If you need to open the door, please read carefully "Emer-

gency door opening".

ENGLISH