AEG KO-LAVAMAT 88840 Manual do utilizador - Página 33
Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar roupa AEG KO-LAVAMAT 88840. AEG KO-LAVAMAT 88840 48 páginas. Aeg prosteam condenser dryer user manual
Imprimir página
Drying results unsatisfactory.
Loading door does not close.
Message on the display: Please
check if the door is closed prop-
erly and then press START.
When a button is pressed - no
reaction of the machine.
Drum light does not work.
Displayed programme time
changes erratically or stays un-
changed for a long time.
Programme inactive, massages:
The tank is full. Please empty it
and then press START or Please
empty the tank. are displayed.
Drying cycle ends shortly after
programme starts. Finished
message is displayed.
Wrong programme selected.
Lint filters clogged.
Fluff filter clogged.
Heat exchanger clogged with
lint.
Overloading of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at in-
stallation site differs from
standard setting of machine.
Fine strainer not in place and/
or mesh filter not locked in
place.
Drying protection. After the
start of the programme, the
option can no longer be set.
Programme selector in OFF po-
sition.
Defective light bulb.
Programme time is corrected
automatically depending on
type and volume of laundry
and level of dampness.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
What to do if ...
Select a different programme
the next time you dry (see "Pro-
gramme chart" chapter).
Clean lint filters.
Clean fluff filter.
Clean heat exchanger.
Observe recommended loading
volumes.
Uncover ventilation slots in
base area.
Clean inside surface of drum
and drum ribs.
Make an adjustment using the
DRYNESS function (see chap-
ter "Drying")
Re-programme standard set-
ting for degree of drying (see
'Programming options' chap-
ter).
Install fine strainer and/or snap
large mesh filter into place.
Turn the programme knob to
OFF. Set the programme again.
Turn programme selector to
DRUM LIGHT or to any pro-
gramme.
Replace light bulb (see next
section).
Automatic process; this is not a
machine fault.
Empty condensate tank, then
start programme with START
PAUSE button.
Select time programme or
higher drying level (e.g. CUP-
BOARD DRY instead of DAMP).
33