AEG L 87405 FL Manual do utilizador - Página 27

Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar roupa AEG L 87405 FL. AEG L 87405 FL 32 páginas. Clothes washer
Também para AEG L 87405 FL: Manual do utilizador (28 páginas)

Imprimir página

Problem

The spin phase does not

operate or the washing

cycle lasts longer than

usually.

There is water on the

floor.

You cannot open the ap-

pliance door.

The appliance makes an

unusual noise.

The cycle is shorter than

the time displayed.

The cycle is longer than

the time displayed.

The washing results are

not satisfactory.

You cannot set an op-

tion.

After the check, activate the appliance. The programme continues from the point of

interruption.

If the problem occurs again, contact the Authorised Service Centre.

If the display shows other alarm codes. Deactivate and activate the appliance. If the

problem continues, contact the Authorised Service Centre.

Possible solution

• Set the spin option.

• Set the drain option if you set an option which ends with

water in the drum.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to 'Care and cleaning'.

• Adjust manually the items in the tub and start the spin

phase again. This problem may be caused by balance prob-

lems.

• Make sure that the couplings of the water hoses are tight

and there is not water leakages.

• Make sure that the water inlet hose and the drain hose have

no damages.

• Make sure you use the correct detergent and the correct

quantity of it.

• Make sure that the washing programme is finished.

• Set the drain or the spin option if there is water in the drum.

• Do the emergency drain procedure. See "Frost precau-

tions" (in "Care and Cleaning" chapter).

• Make sure that the appliance receives electrical power.

• This problem may be caused by a failure of the appliance.

Contact the Authorised Service Centre. If you need to open

the lid, please read carefully "Emergency door opening".

• Make sure the levelling of the appliance is correct. Refer to

'Installation instruction'.

• Make sure that the packaging and/or the transit bolts are

removed. Refer to 'Installation instruction'.

• Add more laundry in the drum. The load may be too small.

• The appliance calculates a new time according to the laun-

dry load. See the 'Consumption Values' chapter.

• An unbalanced laundry load increases the duration time.

This is a normal behaviour of the appliance.

• Increase the detergent quantity or use a different deter-

gent.

• Use special products to remove the stubborn stains before

you wash the laundry.

• Make sure that you set the correct temperature.

• Decrease the laundry load.

• Make sure that you press only the wanted touch button(s).

ENGLISH