AEG L 87695 WD Manual do utilizador - Página 36

Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar roupa AEG L 87695 WD. AEG L 87695 WD 44 páginas.

Imprimir página

36 www.aeg.com

Problem

The appliance fills

with water and

drain immediately.

The washing re-

sults are not satis-

factory.

The appliance

does not dry or

does not dry cor-

rectly.

The laundry is full

of different colours

fluff.

After the check, activate the appliance.

The programme continues from the point

of interruption.

If the problem occurs again, contact the

service centre.

If the display shows other alarm codes,

contact the service centre.

Possible cause

The end of the drain

hose is too low.

The detergent you used

was not sufficient or cor-

rect.

You did not remove the

stubborn stains before

you wash the laundry.

Incorrect temperature

was set.

Too much laundry load.

The water tap is not

turned on.

The drain filter is clog-

ged.

There is too much laun-

dry in the drum.

You have set a wrong

dryness level or drying

time.

The fabrics washed in the

cycle before released

fluff of different colours.

If there is a big quantity

of fluff in the drum re-

peat this procedure

again and again:

Possible solution

Make sure that the drain hose is

in the correct position.

Increase the detergent quantity

or use a different one.

Use special products to remove

the stubborn stains.

Make sure that you set the cor-

rect temperature.

Decrease the laundry load.

Turn the tap on.

Clean the drain filter.

Reduce the laundry load.

Set additional drying time.

• The drying phase helps to re-

move some fluff.

• Clean the laundry with a fluff

remover.

• Clean the empty drum, the

gasket and the door with a wet

cloth.

• Set a rinse cycle

• Put a wool or piled fabric cloth

in the drum.

• Set a drying cycle of 10 mi-

nutes

• Remove the old wool cloth.