Fujitsu PRIMEQUEST 2000 Series Manual de configuração - Página 9
Procurar online ou descarregar pdf Manual de configuração para Servidor Fujitsu PRIMEQUEST 2000 Series. Fujitsu PRIMEQUEST 2000 Series 43 páginas.
Também para Fujitsu PRIMEQUEST 2000 Series: Manual de iniciação (12 páginas), Manual de instalação (29 páginas)
Imprimir página
3. Setting of PXE Boot Parameters
This section describes the modification procedure of CNA Personality setup.
Screen images of the utility might look different with the firmware version of the CNA, although, the
items to be set to the utility are the same. Refer the screen images appropriately.
The following example shows Legacy mode.
You can change to Legacy mode from UEFI mode by Boot Maintenance Manager. (refer to 5.1 Section.)
3.1. PXESelect Utility (Legacy mode)
During the system is starting up, if prompt of PXESelect Utility is displayed as shown below, then press <Ctrl> +
<P> key.
As Controller Configuration screen is displayed, set MultiChannel to DISABLED.
Copyright 2016 FUJITSU LIMITED
Figure 3-1
Figure 3-2
9
CA92344-0966-01