Fujitsu Primergy ECONEL 100 S2 Manual de início - Página 5
Procurar online ou descarregar pdf Manual de início para Servidor Fujitsu Primergy ECONEL 100 S2. Fujitsu Primergy ECONEL 100 S2 9 páginas. Mono-processor tower server
Também para Fujitsu Primergy ECONEL 100 S2: Manual de configuração do sistema e de informações sobre encomendas (7 páginas)
Imprimir página
8
Turning off the power and installing optional devices
Install optional devices after the OS installation.
"Chapter 6 Installing Hardware Options"
1
Check that no medium is inserted in
the floppy disk drive or CD/DVD drive.
2
Exit the operating system (OS).
After the OS is exited, the server is automatically
turned off.
When the server is not turned off after the OS is
exited, press the power switch on the front of the
server.
3
Turn off the power supply of the periph-
eral devices, such as the display.
4
Install the optional devices.
9
Hints for error handling
In preparation for a failure, set the following.
"Chapter 4 Operations after OS Installation"
- Set to collect memory dump
If the memory dump is set, debugging information is automatically saved when the STOP error occurs in the system.
This helps to analyze the cause of errors.
- Create a system restoration disk
When the system file or system environments are damaged, the system can be reconstructed with the contents saved in the sys-
tem restoration disk.
- Store system settings
By storing the BIOS setting information, the original information can be recovered with the stored information in case that the
setting information is lost. The stored information is also used for the system maintenance.
When the settings are completed, make sure to check notes before operation.
"4.5 Notes Before Operating the Server"
For details about maintenance after operations have started, refer to "User's Guide Chapter 8 Operating and
Maintenance".
- After optional devices are installed, set the BIOS
Setup Utility as required. For details about setting
procedures, refer to the "User's Guide Chapter 7
Configuring Hardware and Utilities".
- If an UPS device is installed, set the BIOS Setup
Utility as required. For details, refer to the "User'
s Guide 4.5.3 Notes on Advanced Uninterruptible
Power Supply (UPS)".
When turning on the server again after turning it
off, wait for at least ten seconds and then press the
power switch.
If the server is turned on straight after being turned
off, error will occur that may be cause damage.
5