Fujitsu PRIMERGY TX1330 M4 Boletim de informação do serviço de apoio ao cliente - Página 2

Procurar online ou descarregar pdf Boletim de informação do serviço de apoio ao cliente para Servidor Fujitsu PRIMERGY TX1330 M4. Fujitsu PRIMERGY TX1330 M4 3 páginas. Customer information bulletin

Fujitsu PRIMERGY TX1330 M4 Boletim de informação do serviço de apoio ao cliente
PRIMERGY
1. Disconnect the power cables
2. Open the housing and locate the jumper block for UEFI Recovery (RCVR) /
Password Clear (PWD CLR)
 Consult the relevant PRIMERGY Maintenance Manual from
http://manuals.ts.fujitsu.com
 The board schematic sticker on the inside can guide to the location of the
RCVR/PWD CLR jumper block
 See an example of the jumper block in Fig.1 and a schematic on Fig.1a
below showing the neutral position (Default)
Fig. 1: Jumper in neutral position
3. Set the jumper to 'PWD CLR' position as shown in Fig. 2 and Fig. 2a (schematic)
4. Connect the power cables. The fans will still speed up. Wait until the monitor
displays POST after about 2 minutes by when the iRMC should be ready. A
CUSTOMER INFORMATION BULLETIN
for help to open the housing