Fujitsu SPARC Enterprise T2000 Manual de iniciação - Página 3
Procurar online ou descarregar pdf Manual de iniciação para Servidor Fujitsu SPARC Enterprise T2000. Fujitsu SPARC Enterprise T2000 12 páginas.
Também para Fujitsu SPARC Enterprise T2000: Manual de iniciação (2 páginas), Notas de produto (30 páginas), Notas de produto (28 páginas)
Imprimir página
Quick Setup Instructions
1. Unpack the server, and check that you received all of the shipping contents.
2. Place the server in its intended location for verification.
For rackmounting instructions, refer to the instructions included with the rail kit, the service label on the
server, and to the online SPARC Enterprise T2000 Server Installation Guide.
3. Connect a serial cable between the server's SER MGT port (
This connection provides your initial communication with the system controller (SC).
The device must be set up to communicate using 9600 baud, 8 bit, no parity, 1 stop bit. A null modem
configuration is needed, meaning the transmit and receive signals are reversed (crossed over) for DTE to
DTE communications. You can use the supplied RJ-45 crossover adapters with a standard RJ-45 cable to
achieve the null modem configuration.
Server Connections
FIGURE 2
4. (Optional) Connect an Ethernet cable between the server's NET MGT port (
which future connections to the SC and host will be made.
After the initial configuration of the system using the SER MGT port, communication with the SC and host is
usually performed through this Ethernet interface. To enable this port you must configure it (configure IP
addresses and so forth). Refer to the SPARC Enterprise T2000 Server Installation Guide for instructions.
5. Connect an Ethernet cable between one of the server's NET ports (
server will communicate.
) and a terminal device.
FIGURE 2
FIGURE 2
) and the network to which the
FIGURE 2
) and the network to