Fujitsu fi-6770 Series Manual de iniciação - Página 16

Procurar online ou descarregar pdf Manual de iniciação para Scanner Fujitsu fi-6770 Series. Fujitsu fi-6770 Series 26 páginas. Image scanner
Também para Fujitsu fi-6770 Series: Manual do utilizador (26 páginas), Manual de procedimentos de instalação (6 páginas), Brochura (2 páginas), Manual de iniciação (14 páginas), Instruções de substituição e limpeza de consumíveis (22 páginas)

Make sure that the computer is turned OFF.

Open the Cable Cover (ADF type only).

Connect the scanner to your computer either with a USB or SCSI cable.

• You cannot make both USB and SCSI cable connections at the same time.

• You cannot connect multiple computers to the scanner at the same time.

• Turn off the scanner and your computer first when you switch the interface cable.

The following describes the requirements for connecting with the respective cables.

■

USB cable

• Be sure to use the USB cable which comes as an accessory with this scanner.

• When connecting to an USB hub, use the first stage USB hub that is closest to the computer. If you use

the second or later hub stages, the scanner may not operate correctly.

• If you connect the scanner with USB 2.0, it is required that the USB port and the Hub be compliant with

USB 2.0. The scanning speed slows down when you connect the scanner with USB 1.1.

■

SCSI cable

Be careful not to damage any pins of the SCSI connector when connecting the scanner to

your computer.

• When using the scanner with a SCSI interface, the following types of SCSI cable and SCSI card must

be purchased.

• SCSI cable:

Use a SCSI cable whose connector on the computer side mates to the connector on the SCSI card

installed on your computer.

On the scanner side, use a 50-pin high-density type SCSI cable.

• SCSI card:

Find the recommended SCSI card information on the Fujitsu website (FAQ):

http://www.fujitsu.com/global/support/computing/peripheral/scanners/scsi/

• In a SCSI daisy chain formation, connect the scanner so that it is the terminated device.

• The SCSI ID initially set at the factory is [5]. If the SCSI ID of another SCSI device is set to the same ID,

change the scanner's SCSI ID to [0] through [7].

Connect the Power cable to the Power Connector of your scanner and to the

power outlet.

ARNI N G

Close the Cable Cover (ADF type only).

Let the cables out from the side slots of the scanner.

Be sure to use the supplied power cable. Use of other power cables may cause

electrical shock or malfunction.

Do not use the supplied power cable for other products. Doing so may cause

electrical shock or malfunction.