2.
Connect the scanner to your computer
either with a USB or SCSI cable.
You cannot make both USB and
SCSI cable connections at the
same time.
You cannot connect multiple
computers to the scanner at the
same time.
Turn off the scanner and your
computer whenever you switch the
interface cable.
The following describes the requirements for
connecting with the respective cables.
USB cable
-Be sure to use the USB cable which comes
as an accessory with this scanner.
-When connecting to an USB hub, use the
first stage USB hub that is closest to the
computer. If you use the second or later hub
stages, the scanner may not operate cor-
rectly.
-If you connect the scanner with USB 2.0, it
is required that the USB port and the hub be
compliant with USB 2.0. The scanning
speed slows down when you connect the
scanner with USB 1.1.
SCSI cable
Be careful not to damage any pins of
the SCSI connector when connecting
the scanner to your computer.
-When using the scanner with a SCSI inter-
face, the following types of SCSI cable and
SCSI card must be purchased.
SCSI cable:
Use a SCSI cable whose connector on the
computer side mates to the connector on
the SCSI card installed on your computer.
On the scanner side, use a 50-pin high-
density type SCSI cable.
SCSI Connector 1: 50-pin high-density type
SCSI Connector 2: 68-pin high-density type
SCSI card:
Find the recommended SCSI card informa-
tion on the Fujitsu website (FAQ):
http://www.fujitsu.com/global/support/com-
puting/peripheral/scanners/scsi/
-In a SCSI daisy chain formation, connect
the scanner so that it is the terminated
device.
-The SCSI ID initially set at the factory is [5].
If the SCSI ID of another SCSI device is set
to the same ID, change the scanner's SCSI
ID to [0] through [6].
3.
Connect the power cable to the power
connector of your scanner and to the
power outlet.
WARNING
Be sure to use the supplied power cable.
The following cases may cause electrical
shock or malfunction.
Using a power cable other than that
supplied
Using the supplied power cable for other
devices
Test-Scanning Documents
Using ScandAll PRO, you can test-scan docu-
ments to check if they are scanned correctly.
For details about scanning documents by using
PaperStream Capture and the PaperStream IP
driver, refer to the help of each software.
The following describes how to test-scan a
document:
1.
Turn on the scanner.
1. Press the "I" side of the main power switch on
the rear side of the scanner.
2. Press the power button on the front of the
scanner. The scanner is turned ON, the
power button lights in blue, and the liquid
crystal display (LCD) shows [Ready].
If you see an error indication other
than the above on the LCD, refer to
"Chapter 8 Troubleshooting" in the
Operator's Guide.
5
LCD
Menu
Function
/Enter
Send to
Clear
Check
/Pause
/Back
Overlay
Stop
Scan
Counter
iMFF
Reset
Eject
Power Button
Imprimir página