Fujitsu Fujitsu fi-5950 Começar a trabalhar - Página 8

Procurar online ou descarregar pdf Começar a trabalhar para Scanner Fujitsu Fujitsu fi-5950. Fujitsu Fujitsu fi-5950 11 páginas. Image scanner
Também para Fujitsu Fujitsu fi-5950: Começar a trabalhar (27 páginas), Brochura e especificações (4 páginas), Instruções de substituição e limpeza de consumíveis (24 páginas)

Imprimir página
Fujitsu Fujitsu fi-5950 Começar a trabalhar
Installation (Custom)
1. Perform steps 1. to 3. in
mended)" (page.
2. Click the [Installation (Custom)] button.
3. Select the check box for the software to install
and click the [Next] button.
4. Follow the instructions on the screen to pro-
ceed with the installation.
"Installation (Recom-
7).
2.4 Checking Scanner Driver
Operation
This section explains how to check the operation of the
installed scanner driver by using ScandAll PRO.
For details about scanning documents by using Paper-
Stream Capture and the PaperStream IP driver, refer to
the help of each software.
Make sure that the scanner driver is installed properly,
following the procedure below.
■ Checking the Operation of the

Scanner Driver

1.
Load the document on the scanner.
For information about how to load the document, refer
to section "2.6 Loading Documents on the ADF for
Scanning" in the "fi-5950 Operator's Guide."
2.
Launch ScandAll PRO.
From the [start] menu, select [All Programs]
[Fujitsu ScandAll PRO]
3.
In ScandAll PRO, select [Tool] on the menu, and
then select [Preferences].
⇒
The [Setup] dialog box appears.
4.
On the [Scan] tab, select a driver.
To check the operation of TWAIN driver, select
[TWAIN].
To check the operation of the ISIS driver, select [ISIS].
5.
Click the [OK] button to close the [Setup] dialog
box.
6.
In ScandAll PRO, select [Scan] on the menu, and
then select [Select Scanner].
7.
Select a scanner in the displayed dialog box.
To use TWAIN driver:
Select [FUJITSU fi-5950d], and then click the [Select]
button.
To use ISIS driver:
Select [Fujitsu fi-5950], and then click the [Select]
button.
8.
Select [Scan] on the menu, and then select [Scan
Settings].
8
[ScandAll PRO].