Brother Business Smart MFC-J4510dw Manual de Segurança do Produto - Página 16

Procurar online ou descarregar pdf Manual de Segurança do Produto para Servidor de impressão Brother Business Smart MFC-J4510dw. Brother Business Smart MFC-J4510dw 25 páginas. Quick setup guide - spanish
Também para Brother Business Smart MFC-J4510dw: Manual (36 páginas), Manual (22 páginas), Manual de Segurança do Produto (17 páginas), Manual (13 páginas), Manual (22 páginas), Manual de configuração rápida (47 páginas), Manual (18 páginas), Manual de configuração rápida (47 páginas), Brochura e especificações (4 páginas), Manual de Segurança do Produto (20 páginas), Especificações (2 páginas), Manual de configuração rápida (47 páginas), Manual de início rápido (29 páginas), (Espanhol) Guia De Web Connect Manual (38 páginas), (Espanhol) Manual (24 páginas), (Inglês) Manual do Guia de Segurança do Produto (16 páginas), (Espanhol) Manual (11 páginas), (Inglês) Guia de configuração rápida (47 páginas)

27 This equipment is not capable, under all operating conditions, of correct operation at the higher

speeds for which it is designed. Telecom will accept no responsibility should difficulties arise

in such circumstances. This condition typically applies to 56 kbit/s modems and facsimile

machines operating at >14.4 kbit/s.

28 When using the Caller Line Identification incorporated in this device, verify the integrity of the

recorded digits prior to dialling.

29 Some parameters required for compliance with Telecom's Telepermit requirements are

dependent on the equipment (PC) associated with this device. The associated equipment shall

be set to operate within the following limits for compliance with Telecom's Specifications:

There shall be no more than 10 call attempts to the same number within any 30 minute



period for any single manual call initiation.

The equipment shall go on-hook for a period of not less than 30 seconds between the end



of one attempt and the beginning of the next call attempt.



Automatic calls to different numbers are spaced such that there is not less than 5 seconds

between the end of one call attempt and the beginning of another.



Equipment shall be set to ensure that calls are answered within 3 and 30 seconds of the

receipt of ringing.

30 In the event of any problem with this device, it is to be disconnected, and a CPE item connected

to one of its terminal ports may be connected directly in its place.

The user should then arrange for the product to be repaired. Should the matter be reported to

Telecom as a wiring fault and the fault is proven to be due to this product, a call out charge will

be incurred by the customer.

31 The Caller ID telephone numbers that are displayed and stored in this equipment include the

caller's area code but not the toll access "0" prefix. When calling back it is necessary to add a

"0" to the telephone number, or if the telephone number is a local number, omit the area code

digit. If the toll services of a service provider other than Telecom are being used then a toll

charge may be incurred if the "0" prefix toll access code and area code are used.